Operator's Manual

1. Safety
1.1 Overview of residual risks
Residual risk Hazard area Type of danger Measure to be taken by the
user
Mechanical hazard
Bruises or knocks due to falling
satellites
Satellite Risk of injury Cordon off the work area below
the assembly area.
Use the enclosed brackets or
own-construction brackets
according to the Operator's
manual. Use the screw locks.
Bruises, knocks due to falling
charging station
Charging station Secure the charging station to
the wall or table using screws/
bolts.
Slipping, stumbling, falling over
charging station placed in path
Charging station Secure the charging station to
the wall or table using screws/
bolts.
Bruises or knocks due to a fall-
ing industrial PC
Industrial PC Secure industrial PC to wall or
table using screws/bolts.
Slipping, stumbling, falling over
industrial PC placed in path
Industrial PC Secure industrial PC to wall or
table using screws/bolts.
Falling from lifting device/ladder Lifting device/ladder Use suitable lifting devices and
ladders.
These should be assembled by
qualified personnel only.
Cuts due to edge of satellite
retaining bracket
Sharp edge of
retaining bracket
During assembly, wear gloves.
Residual risks Tab. 1
FCC - safety and compliance
This device complies with Part 15 of the Federal Communica-
tions Commission (FCC) Rules. Operation is subject to the fol-
lowing two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired opera-
tion.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable pro-
tection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not
occur in a particular installation.
2
Safety
2020-10-01 B1105en