Quick Start Guide

Bluetooth Audio Speaker - USER’S MANUAL
4
Configuration on a Mac system
- Click on the Bluetooth icon in the taskbar.
- Make sure Bluetooth is on.
- Go to ‘set up Bluetooth device…’.
- Select ‘Trust BT Audio’ in the list of Bluetooth devices (make sure the device is in pairing mode).
- Click on ‘Continue’.
- If the pairing attempt was unsuccessful. Go to ‘Passcode options’.
- Select ‘Use a specific passcode’.
- The passcode to use is ‘0000’.
- Click on ‘ok’.
- Click on ‘Continue’.
- Your device is now ready to use.
Advanced Controls
Standby
By pressing and holding the volume control for 4 seconds the speaker goes into standby mode (LED
flashing red 1x every second).
T
o power the speaker back on, press the volume control for 1 second.
Volume/ Treble/ Bass control
Press the volume control when playing music to switch between volume, treble, and bass.
Speaker memory
T
he speaker has an build in memory. So that every time you power on the speaker and your music
device they will automatically connect.
T
o clear the memory of the speaker press and hold the play/pause button for 5 seconds.
Change audio input
T
he speaker has 2 different audio inputs. Bluetooth and 3.5mm audio.
By pressing the input selection button ‘A’ you can switch between these inputs.
T
he LED light indicates the selected input source: - Blue Led: Bluetooth
- Red LED: 3.5mm audio input