User's Manual

- 45 -
Print mode
This item is used to set the print mode. There are 3 modes as below,
Printer Mode Description
None
Next label top of form is aligned to the print
head burn line location. (Tear Off Mode)
Batch Mode
Once image is printed completely, label
gap/black mark will be fed to the tear plate
location for tear away.
Peeler Mode Enable the label peel off mode.
Batch
Mode
Offset
This item is used to fine tune media stop location. Available setting
value is from “+” to “-” or “0” to “9”.
+000
Shift X
This item is used to fine tune print position. Available setting value is
from “+” to “-” or “0” to “9”.
+000
Shift Y +000
Reference X
This item is used to set the origin of printer coordinate system horizontally
and vertically.
Available setting value is from “0” to “9”.
000
Reference Y 000
Code page
Use this item to set the code page of international character set.
850
Country
Use this option to set the country code.
001
Note: If printing from enclosed software/driver, the software/driver will send out the
commands, which will overwrite the settings set from the panel.