OPERATING MANUAL CH-22 MULTI-TIRE CHANGER READ INSTRUCTIONS THOROUGHLY BEFORE OPERATING 800.223.4540 3451 S. 40th Street Phoenix, AZ 85040 602.437.5020 May 9, 2017 www.tsissg.com info@tsissg.com Fax 602.437.
GENERAL INFORMATION General: Remove contents from box and assemble as shown below in Fig. 1. Read and follow instructions for optimum use. Overview: The CH-22 Multi-Tire Changer accommodates tires ranging from 4” to 16.5” in diameter. This is made possible by using different center posts and varying the position of the jaw clamps.
INSTRUCTIONS Set-Up One of several design features to the CH-22 includes options to mount it. For best results TSI has developed a Platform and Stand to compliment the CH-22 function and range. The Platform (TSI PN 6192) provides a non-slip footing surface for a service technician. Likewise the CH-23 Stand puts the work being done with the CH-22 at a good height along with including a very handy Bead Breaker and tool storage center. Bolt them together (using the bolt holes on Pg. 2 Fig.
INSTRUCTIONS (CONTINUED) Ideally the rim should be centered over the center hole on the Tire Changer. Before cinching the rim tight, determine which center post to use. If the wheel has a hole through it large enough to use the large center post, use it. If it’s seated with a bearing (see Fig. 5) use the appropriate sized shaft 1/2”, 5/8” or 3/4” from either of the center posts available. Now tighten the adjusting clamp to secure the wheel. Tip: Make sure to secure the edge of the rim (see Fig. 6). Fig.
Demount deflated tire using the "rod end" of the Mongoose Tire Tool (see Fig. 7). The ball end is pushed under the top bead and rested on the rim as illustrated. While holding the Mongoose Tool against the center post with one hand, and lifting up on the tire with the other, rotate the tool full circle. Demount the bottom bead the same way.
INSTRUCTIONS (CONTINUED) Fig. 11 Fig. 10 Shove the Demount tab into the rim flange area (see Fig. 10). With your other hand guide the tire beads into the ‘drop center’ of the rim opposite the side where you’ve placed the Mongoose Tire Tool and demount tab. Pry up on the Mongoose Tire Tool and demount tab in an arced motion so they rest on the rim as shown in Fig. 11. With the tool against the center post rotate them in a circular motion around the post until the tire is free from the rim.
SPECIFICATIONS Specifications The CH-22 weights 26 pounds packaged. Triangular in shape it takes up roughly a 24” square area by 7” tall fully assembled (without the center posts.) Ideally an operator needs free mobility all the way around for best results.
OPTIONS AND ACCESSORIES CH-23 Stand w/ Bead Breaker Floor Plate PN 6192 Mini Mongoose PN CH-4M Wheel Protectors 12488 / 12489 www.tsissg.com CH-22 MULTI-TIRE CHANGER 800.223.4540 3451 S. 40th Street Phoenix, AZ 85040 602.437.5020 www.tsissg.com info@tsissg.com Fax 602.437.
