Spec Sheet

Page | 1 22
nd
April 2013 v1.4
Product Specification
1101 UHF RFID reader for the Motorola MC70/75/75A
1101 UHF RFID reader for
the Motorola MC70/75/75A
High Performance Upgrade
The 1101 UHF RFID Reader provides a UHF RFID
upgrade path for Motorola MC70, MC75 and
MC75A terminals. It snaps on to the bottom of
the host terminal and uses the serial port for all
data communications.
The reader supports reading and writing of EPC
Class 1 Generation 2 (ISO 18000-6C)
transponders, and has been designed for
operation in European (ETSI EN 302 208) and
US (FCC Part 15) regulatory environments,
including Dense Reader Mode Capability.
The rugged design of the UHF reader means that
it can withstand multiple drops of up to 1.3m
(4.26ft) to concrete.
Independent Power
A rechargeable battery is included in the
reader to avoid reducing the run time of the
host terminal. The battery is normally charged
in the reader, but can be swapped out in
applications requiring continuous operation.
Simultaneous Charging
The combined DC input and USB connector at
the base of the unit socket enable
simultaneous charging of both the UHF
Reader battery and the MC70/75/75A
battery, as well as ActiveSync with the host
device.
An extensive software development kit (SDK)
is available for development of customer
applications.
Features:
High Performance antenna
Integrated circularly polarised
antenna facing out from rear of
reader (and host terminal)
Simplicity
Reader snaps on to host terminal
to provide “one piece, one charge”
reader solution. Optional locking
screws make the attachment
semi-permanent.
Long run time
10 hours on a single charge
performing 3000 inventory cycles
every hour
Easy integration
SmartWedge software for
Windows Mobile devices enables
straightforward integration with
form based applications,
supporting most of the commonly
used Control characters.
Snap-on UHF RFID Reader