Installation Manual

Mounting with Vandal Resistant Cover Accessory
The optional vandal resistant cover (VRC) accessory provides durability and protection against vandalism and
malicious damage. The flush design also serves as an anti-ligature measure for an additional level of safety.
P
UL
ULC
The vandal resistant cover accessory has not been evaluated for UL/ULC applications.
Sealing Gasket
The gasket included with the VRCprovides a sealing layer between the mounting surface and the reader/cover to
help ensure a sealed vandal-proof installation. The gasket is provided in two distinct pieces, allowing for easy
alignment with the hardware and mounting holes. The smaller inner piece is shaped to fit the reader, while the
larger outer piece is shaped to fit the vandal resistant cover. The adhesive side of the gasket may be applied to
either the mounting surface or the hardware, to suit installation conditions and preference.
Mounting the Reader with Vandal Resistant Cover
1. Select where to mount the card reader, ensuring it is mounted a minimum of 1.1m (3.5ft) away from other
wiring, such as ACM power, computer data wiring, telephone wiring and wiring to electric locking devices.
2. Use the drill template sticker provided with the card reader as a guide to correctly position the unit and drill
the necessary holes as instructed.
The drill template is also available from the ICT website.
3. The reader's cable connection socket should align with the 'connector' hole cut through the wall. Cables are
intended to be run inside the wall.
4. If using cavity anchors, affix the anchors (not supplied) into the wall.
5. Remove the backing tape from the smaller (reader) gasket and place it carefully in position with the mounting
holes and cable entry aligned, then apply pressure to ensure the gasket is securely adhered in place.
It may be preferable to adhere the gasket to the back of the reader case, aligned with the mounting holes and
cable entry, and affix the reader case to the wall with the gasket attached.
6. Run the module network wiring and connect to the reader wiring loom provided. Refer to the Connections
section (see page20) for the electrical connections.
7. Connect the wiring loom Hirose socket plug to the connection socket on the back of the reader.
8. Use appropriate screws (not supplied) to securely fasten the reader body to the wall or cavity anchors, aligned
over the gasket.
It is strongly recommended to fasten screws by hand to avoid potential damage to the reader.
9. Position the cover over the reader body, ensuring the top clip snaps into place.
10. Using the M3(G4)x4 Plastite self-tapping screw provided, secure and fasten the front case to the rear mounted
case via the hole at the bottom.
11. Apply a silicone seal around the top and sides of the reader (see below).
12. Remove the backing tape from the larger (VRC) gasket and place it carefully in position around the reader,
then apply pressure to ensure the gasket is securely adhered in place.
It may be preferable to adhere the gasket to the back of the vandal resistant cover, aligned with the mounting
holes, and affix the cover to the wall with the gasket attached.
13. Use appropriate screws (not supplied) to affix the vandal resistant cover to the wall, aligned over the gasket.
TSL Multi-Technology Card Reader | Installation Manual 16