Installation Manual
Table Of Contents
- Introduction
- Reader Editions
- Reader Accessories
- MIFARE Technology
- Installation Requirements
- Mounting
- Reader Connection
- Programming the Card Reader
- Technical Diagrams
- Technical Specifications
- New Zealand and Australia
- European Standards
- UK Conformity Assessment Mark
- UL and ULC Installation Requirements
- FCC Compliance Statements
- Industry Canada Statement
- Disclaimer and Warranty
OSDPBaud Rate Requirement
For a card reader operating in OSDPmode to communicate with an OSDP server, the reader must have the same
baud rate setting as the reader port it is connected to. The default reader baud rate is 38400.
ICT card readers support the following baud rates:
Supported Baud Rates
4800 baud
9600 baud
19200 baud
38400 baud (default)
57600 baud
115200 baud
The card reader baud rate can be programmed using a mobile device running the Protege Config App.
The ConfigApp Reader Configuration will need a config with the Uart Configuration TLV selected, with the Baud
set to match the connected reader port.
For detailed information on programming ICT card readers, see the ICT Card Reader Configuration Guide, available
from the ICT website.
OSDPReader Addressing
For a card reader operating in OSDPmode to be recognized on a third-party system, the reader address may need
to be configured to meet the third-party system's addressing requirements.
The address of TSL card readers can be programmed using a mobile device running the Protege Config App. The
ConfigApp Reader Configuration will need a config with the Reader Address TLV selected, with the address set
as required for the third-party system.
TSL Multi-Technology Card Reader | Installation Manual 26