User Manual

11
sound is detected by Baby unit. LCD screen would be turned off if no sound is detected by baby unit
within 1 minute. Once the sound is detected, it will automatically turn on the LCD screen. This is also
power saving feature.
C2. Out of Range Alert
When the connection between both units is broken (e.g.
Baby unit is turned off; OR the units are detected out of
communication range (beyond 150m) OR Baby unit is in
low power), the out of range alert will be activated. A rapid “Di Di” sound would be heard and No
signal image would be shown on the LCD screen until the connection comes back again.
Location and Set Up
You can position and adjust the Baby Unit in a variety of ways to provide the best view of your baby.
To optimize the performance, position the monitor unit 3 ft (1m) away from the baby.
A. Set up removable Mounting Clip
The Baby Unit can be clip on the table edge by setting up the removable mounting clip. After
inserting the mounting clip at the base bottom, user can easily fix the Baby Unit into different location.
Setting and disassembly method are shown in the figure below.
Setting
Disassembly
B. Wall Mount
User can mount the baby unit or the parent unit at wall or ceiling by the wall mount hole.
C. Detachable and Rotary Base and Belt Clip for Parent Unit
User can select rotary base or belt clip for parent unit according to different usage, such as user can
bring the parent unit around the house with belt clip. Refer to the figure below:
Setting the base Disassembly Setting the belt clip Disassembly
Also you may adjust the supporting pole by max. 70° and optionally rotate base by 360° .