User Manual

3
Privacy Protection
Always remember that you are using public airwaves when you use the Wireless 2.4GHz Digital
Baby Monitor. Sound and video may be broadcasted to other receiving devices. Conversations, even
from rooms near the camera, may be broadcast as well.
CAUTION: To protect your privacy, always turn the system off when not in use. It is possible that the
Parent Unit may be interfered from other devices in the 2.4GHz frequency range. To minimize this
potential problem, over 18 digital channels have been provided for your use.
Battery Installation
Installation
1. Remove screw by a screwdriver.
2. Open the battery door.
3. Insert 3 AA alkaline batteries into the Baby unit and 3 AA alkaline or rechargeable batteries into the
Parent unit according to the polarity shown in the battery compartment.
4. Replace the battery door at the inclined angle, press down the screw and screw it up again.
Baby Unit Parent Unit
5. User can directly operate the unit by the supplied AC adaptor.
y Use only the AC adaptor included supplied.
y Unwrap and fully extend the AC adaptor cord.
y Plug AC adaptor into a standard wall outlet.
y Wrap up and secure any excess AC adaptor cord.
Battery Tips:
- If the product is not in use for a long time, disconnect both unit from the household electrical outlet.
And remove the batteries or the exhausted batteries from the units, otherwise battery leakage and
corrosion can damage them.
- Dispose the battery safely.
- Non-rechargeable battery is not be recharged. It may have a fire.
- Rechargeable batteries are only to be charged under adult supervision.
Warning!
- The batteries shall not be exposed to excessive heat such as sunshine, fire or the like
- Danger of explosion if battery is incorrectly replaced. Dispose of used batteries according to the
instructions. Replace only with the same and equivalent type. Only use the special
rechargeable battery from TSUEN SHING. (Model No.: BT-100-AA) for Parent unit.
1
2 3 4
3 4
1
2