User Manual

Adjust the appropriate volume level.

Remark: Switch on the night vision when using in the dark, infra-red LED will be activated,

and only Black & White image will be shown.

* For more detailed operation, please go to P.5 “Functions setup”

Reception Testing

Before using the Parent Unit or changing the location of the system, it is very important to test the

video and sound reception:

To test the video reception

1. Place the Baby Unit in the most appropriate location. (e.g. on top of the table, mounting on the

wall or ceiling)

2. Focus the camera lens towards the baby.

3. Check the video reception on screen of the Parent Unit and adjust the appropriate brightness

level. (To adjust brightness, please see the “Functions Setup” section)

To test the sound quality

1. Speak in a whisper and with normal conversation sound level to Baby Unit.

2. Put the Parent Unit far away enough (at least 1m) from Baby Unit to prevent noise feedback.

3. Check the sound reception on speaker of the Parent Unit and adjust the appropriate volume. (To

adjust volume, please see the “Functions Setup” section )

Functions Setup

A. Scan the Corresponding Channel

To offer users with higher flexibility, link key is designed for eliminating the corresponding channel

recorded in the unit and reset a new corresponding channel when necessary.

Power LED of Baby unit flashes green light

and No signal image shown on the LCD screen.

Press the LINK key of the both units.

“OK” be showed “error” be showed

Scanned successfully Scanned unsuccessfully

Remarks: Default setting: Correspondence channel is scanned.