SDS

LN-950 POLYURETHANE AHE95012TN0
Product name
5
Product code
Date of issue
Version
00407720
17 August 2015
Section 15. Regulatory information
Stoddard solvent
Yes.
No.
No.
Yes.
Yes.
-
(2-methoxymethylethoxy)propanol
Yes.
No.
No.
Yes.
No.
-
4,4'-methylenediphenyl diisocyanate
No.
No.
No.
Yes.
Yes.
-
Name
Fire
hazard
Sudden
release of
pressure
Reactive
Immediate
(acute)
health
hazard
Delayed
(chronic)
health
hazard
Additional environmental information is contained on the Environmental Data Sheet for this product, which
can be obtained from your PPG representative.
Section 16. Other information
Key to abbreviations
:
ATE = Acute Toxicity Estimate
BCF = Bioconcentration Factor
GHS = Globally Harmonized System of Classification and Labelling of Chemicals
IATA = International Air Transport Association
IBC = Intermediate Bulk Container
IMDG = International Maritime Dangerous Goods
LogPow = logarithm of the octanol/water partition coefficient
MARPOL 73/78 = International Convention for the Prevention of Pollution From Ships,
1973 as modified by the Protocol of 1978. ("Marpol" = marine pollution)
UN = United Nations
Hazardous Material Information System (U.S.A.)
2
0
2
National Fire Protection Association (U.S.A.)
Health
Instability
Flammability
Health
Flammability
Physical hazards
Disclaimer
The information contained in this data sheet is based on present scientific and technical knowledge. The purpose of this
information is to draw attention to the health and safety aspects concerning the products supplied by PPG, and to
recommend precautionary measures for the storage and handling of the products. No warranty or guarantee is given in
respect of the properties of the products. No liability can be accepted for any failure to observe the precautionary measures
described in this data sheet or for any misuse of the products.
Date of previous issue
5/29/2015
:
Caution: HMIS® ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4 representing significant hazards or
risks Although HMIS® ratings are not required on MSDSs under 29 CFR 1910.1200, the preparer may choose to provide them. HMIS® ratings are
to be used with a fully implemented HMIS® program. HMIS® is a registered mark of the National Paint & Coatings Association (NPCA). HMIS®
materials may be purchased exclusively from J. J. Keller [phone].
The customer is responsible for determining the PPE code for this material.
Indicates information that has changed from previously issued version.
Organization that prepared
the MSDS
:
EHS
:
:
:
:
:
:
2
*
2
0
( * ) - Chronic effects
United States
Page: 14/14