Use and Care Manual

Tsurumi’s Operation, Service, and Repair Manual
Removal/Installation
59
6-9 Installation of Fuel Tank
A. If removed, install fuel shutoff valve (19) in tank (18).
1. If removed, install bushings (26) and cushions (25).
2. Install tank (18) in frame (44) and secure with four bolts (23) and four washers (24).
3. Connect fuel tube (27) to shutoff valve outlet. Secure with clamps (29 and 30).
6-10 Removal/Installation of Generator/Engine Unit
WARNING: THE COMBINED WEIGHT OF THE ASSEMBLED ENGINE AND GENERATOR IS IN
EXCESS OF 125 POUNDS. USE OF AN OVERHEAD LIFTING DEVICE IS
RECOMMENDED.
WARNING: INJURY TO MAINTENANCE PERSONNEL MAY RESULT FROM ATTEMPTING TO LIFT
THE HEAVY ENGINE AND GENERATOR ASSEMBLY FROM THE FRAME WITHOUT
THE AID OF A LIFTING DEVICE.
NOTE: Refer to exploded view in Replacement Parts section for parts information. The item numbers
in the following procedure are identical to those in the Replacement Parts exploded views.
NOTE: Tsurumi recommends that the heavy generator/engine unit be removed from the frame before
removing generator components.
NOTE: The engine and generator wires have in-line plug and socket connectors that can be
disconnected to take electrical measurements or to allow component replacement. Tag both
ends of the wires as they are disconnected. Write the wire color and/or other characteristics
(such as color of stripe) on the tag to assure the wires are properly reconnected.