Use and Care Manual

Tsurumi’s Operation, Service, and Repair Manual
Removal/Installation
61
6-12 Installation of Generator/Engine Unit
A. If you are replacing the stator (8), refer to Replacement of Generator Stator.
1. If you are replacing the rotor (12), refer to Replacement of Rotor.
2. If you are replacing the rotor bearing (13), refer to Replacement of Rotor Bearing.
3. If you are replacing the engine (H-1), refer to Replacement of Engine.
4. Tighten fasteners to the torque values shown in Table 6-1.
5. If anti-vibration mounts (35) are being replaced, proceed as follows:
6. Insert one screw (37) in each of four anti-vibration mounts (35). Install screws (37) so
threaded end of screws (37) face upward.
7. If bonding wire (40) was removed, install screw (43) through hole in the underside of frame
(44) Secure wire with toothed washer (42) and nut (43).
8. Install anti-vibration mounts (with bolts) on frame (44). Install mounts with threaded stud in
large hole and keying tab in the smaller hole in the frame.
NOTE: The anti-vibration mounts on Model TPG4-3000HDX are installed at approximately 45-degees.
The anti-vibration mounts on all other models are installed parallel with the frame member to
which it is attached.
9. Install generator/engine unit on anti-vibration mounts (35) and secure to frame (44) with
flanged nuts (38).
10. Install assembled generator/engine unit over bolts (37) in anti-vibration mounts (35).
11. Install terminal ring of bonding wire (40) on threaded end of bolt (38). Install flanged nuts (36)
on the anti-vibration mounts (35).
12. Install fuel tank (refer to Installation of Fuel Tank).
13. Install control box (refer to Installation of Control Box).
14. Connect engine wiring in panel (46) according to the tags attached to the wires during
disassembly.
NOTE: Replace tube (7) if it was damaged or discarded during repair or replacement of stator (8). After
replacement tube (7) is installed, install grommet (75) over tube (7). Install grommet (75) in the
hole in control box (45).