Use and Care Manual

Tsurumi’s Operation, Service, and Repair Manual
Removal/Installation
64
1
4
15 (4x)
13
10 (4x)
12
11
9
8.1
16
17
7
3
6
5
4 (3x
)
1
2 (2x)
8
TPG4 Fig 6-8
Figure 6-8: Replacement of Stator
12. Align the bore in rear cover (14) with the rotor bearing (13). Position the rear cover (1) with
the hole for grommet (75) aligned with the stator wires.
13. Route the stator wires through grommet (75) and into access hole in the control box (45).
14. Slip tube (7) over the wires. Put tube (7) in the wire access hole making sure the groove in the
tube is seated in the lip of the wire access hole.
15. Install bolts (4). Tighten bolts (4) in small increments and in an alternating pattern. Tighten the
bolts so the stator cover is pulled down evenly against the relief at the edge of the front cover
(14) and rear cover (1). Make sure the thin stator cover is seated all 360 degrees in the relief
on both covers.
16. Tighten fasteners to the torque values shown in Table 6-1.