Use and Care Manual

Tsurumi’s Operation, Service, and Repair Manual
Removal/Installation
67
Oil Container
Rotor
TPG3 FIG 6-
1
1
Wrap tape on bolt
TPG3 FIG 6-
1
2
Figure 6-11: Pouring Oil in Rotor Shaft
14. Refer to Figure 6-12. Wrap electrical tape around the threads of a bolt to form a seal; do not
put tape on the first two threads of the bolt.
NOTE: Use an M8 x 215 bolt for all models.
Figure 6-12: Wrapping Bolt with Tape
NOTE: Have shop towels available to wipe up spilled oil.
15. Install the bolt in the center of the rotor shaft refer (to Figure 6-13). Turn the bolt into the shaft;
the force required to turn the bolt will increase as the pressure increases.
TPG4 FIG 6-11
TPG4 FIG 6-12