Use and Care Manual

Tsurumi’s Operation, Service, and Repair Manual
Removal/Installation
72
(4) Install front panel (46) and control box (45) (refer to Removal/Installation of Front Panel
and Control Box).
4. Pilot Lamp (ALL MODELS)
(1) Refer to Figure 6-14. Remove front panel (45) and control box (45) (refer to
Removal/Installation of Front Panel and Control Box).
(2) Disconnect wire from pilot light (53). Squeeze inward on tab to release the pilot light (53)
from the panel (45).
(3) Install replacement pilot light (53) from front of panel. Install pilot light (53) until the tab
snaps into place.
(4) Connect the wire to the pilot light (53).
(5) Install front panel (46) and control older.
(6) Install replacement fuse (H-TBD) in its fuse holder.
(7) Install front panel (45) and control box (46) (refer to Removal/Installation of Front Panel
and Control Box).
5. Engine Start (Key) Switch (TPG3-7000HDXE)
(1) Refer to Figure 6-14. Pull switch (59) from backside of front panel (46).
(2) Separate switch from its connector box (45) (refer to Removal/Installation of Front Panel
and Control Box).
6. Circuit Breaker (50)
(1) Refer to Figure 36. Remove front panel (45) and control box (46) (refer to
Removal/Installation of Front Panel and Control Box).
(2) Remove two screws
and washers.
(3) Disconnect wiring.
(4) Connect wiring and install replacement breaker (50) in back of front panel (45). Secure with
two screws.
7. Circuit Breaker (51, 52 or 53)
(1) For breaker (51, 52 or 53), remove four screws and washers.
(2) Disconnect wiring.
(3) Connect wiring and install replacement breaker (51, 52 or 53) in back of front panel (45).
Secure with four screws and washers.