Use and Care Manual

Tsurumi’s Operation, Service, and Repair Manual
Removal/Installation
74
(4) Connect wiring and install replacement switch (55) in back of front panel (56). Secure with
two screws (1).
(5) Install front panel (45) and control box (46) (refer to Removal/Installation of Front Panel
and Control Box).
9. Full-power Switch (ModelsTPG3-4500HDX, TPG3-6000HDX, and TPG3-7000HDXE)
(1) Refer to Figure 6-15. Remove front panel (45) and control box (46) (refer to
Removal/Installation of Front Panel and Control Box).
(2) Remove two screws (41) from switch (40).
(3) Disconnect wiring.
(4) Connect wiring and install replacement switch (40) in back of front panel (45) and secure
with two screw and lock washer assemblies (41).
(5) Install front panel (45) and control box (46) (refer to Removal/Installation of Front Panel and
Control Box).
10. Twist Lock Receptacles
(1) Refer to Figure 6-15. Install front panel (45) and control box (46) (refer to
Removal/Installation of Front Panel and Control Box).
(2) For receptacle (47), remove two screws (48).
(3) Disconnect wiring.
(4) Connect wiring and install replacement receptacle (47) in back of front panel (45) and
secure with two screw and lock washer assemblies (48).
(5) For receptacle (49), remove two screw and lock washer assemblies (50).
(6) Disconnect wiring.
(7) Connect wiring and install replacement receptacle (49) in back of front panel (45) and
secure with two screws (50).
(8) Install front panel (29) and control box (46) (refer to Removal/Installation of Front Panel
and Control Box).
11. GFCI Receptacles
(1) Refer to Figure 6-15. Remove front panel (45) and control box (46) (refer to
Removal/Installation of Front Panel and Control Box).
(2) Remove two screw and lock washer assemblies (45) and receptacle (42).
(3) Disconnect wiring and remove receptacle.