User's Manual

explosives or in areas labeled "Blasting Area". Premature or accidental detonation
may result.
•
Do not attempt to modify or in any way increase the output of this transceiver Its
output is designed to meet the legal limits set by the FCC.
• Do not use this device or change its batteries in potentially explosive atmospheres as
sparks in such areas could result in an explosion. Turn your transceiver off wherever
posted notices restrict the use of radios or cellular telephones. Facilities such as
hospitals may use equipment that is sensitive to RF energy.
•
Turn your transceiver off on board aircraft when requested to do so.
•
Do not place your radio in front of a vehicle's air-bag. It the air-bag deploys, it could
propel the transceiver like a projectile causing bodily injury.
Troubleshooting
Problem Possible cause Correction
Weak batteries Charge or replace batteries No transmission while
pressing the PU Button
Incorrect battery polarity Install the batteries
following the directions in
paragraph Installing the
Batteries.
Weak batteries Charge or replace batteries
Channel and privacy
Code not set the same as
target transceiver
Adjust the transceiver’s
Settings to match those
Settings of the target
transceiver
Volume level too low
PTT Button inadvertently
Depressed
Increase volume level
Release PTT Button
Weak or no signal received
Excessive radio
interference on a particular
channel
Obstruction of radio signal
Change to a different
channel
Avoid operating in or near
large buildings or vehicles
Unit beeps, but will not
function when turned on
Batteries extremely
discharged
Charge or replace batteries
CTCSS privacy mode not
on
Turn on the CTCSS privacy
Mode and set code number
to
Match the setting of the
target
transceiver.
Reception of unwanted
signals
Interference from
electronic
devices such as computers
or TVs
Turn the devices off or
move father away from
them.