User's Manual

10/14
7) Beep tone
Hearing this tone, users will make sure that any button has been correctly
pressed.
To set the beep tone
!
Press the Mode button until [
bP On
or
oF
] and the
BELL
icon blink on the
LCD.
!
Press the up[
″
]or down[
…
] button.
!
Press the PTT button or MODE button to confirm.
8) Call Ringer Selection Mode
This feature Provides 3 user selectable call ringer signal.
To set your favorite call ringer signal.
!
Press the MODE button until the [
C
01
or up to
03
] appears on the LCD.
!
Press the up[
″
]or down[
…
] button to select the call melody type.
!
Press the PTT button to confirm.
!
To activate the call, click the “
PTT
” button twice quickly.
9) Out-of-range Alarm
Icon blinks as the receiving signal is getting weaker. The Icon stops blinking
when the receiving signal comes back to normal strength.
10) Transmitting
!
Press and hold the PTT button (The LED light red during transmission.)
!
Speak slowly and clearly
!
To Stop the transmission, release the PTT button.
!
If there is no more receiving signal for 5 seconds, the unit will go into
power save mode.
11) Receiving
The Coding feature reduces the possibility of interference and provide
enhanced Communication. You can only listen to a call which has correct
matching codes.
** Upon receiving a signal, the LED will light green. In case that a signal, which
has different CTCSS channel, is received when the Radio is on the CTCSS mode,
the LED blinks in green.
Important :
Before transmitting or receiving, the users have to make sure that the correct
channel ( 1 to 15 ) and code ( 00 to 38 ) are selected.
12) Channel Scanning