User's Manual

6/14

decrement the listening volume.When in function edit mode,

this button will be used to adjust the unit's settings..

4) Scan / Lock key : Press this button momentarily to enable or disable the

scan mode. Press and hold the button for over 2seconds to lock

or unlock the keypad.

5) Mode (Function) key : Push to select the following function setting mode.

Βριεφ πρεσσ µοδε : 1∋στ πρεσσ Χηαννελ ,

2 νδ πρεσσ ΧΤΧΣΣ,

3 ρδ πρεσσ Ποωερ Ηι / Λο

4∋τη πρεσσ ςΟΞ λεϖελ

5 τη πρεσσ ∆υαλ Ωατχη

6∋τη πρεσσ Ρογερ Βεεπ

7 τη πρεσσ Βεεπ Τονε

8 τη πρεσσ Χαλλ

6) Emergency ( EMG ) Call Button : This radio has a quick access button( EMG ) to

the Emergency and Assistance Channel. This channel is not monitored by

local authorities. When using this channel, EMG appears on the display.

Pressing this button will set the transceiver to the channel 10

7) Speaker / Microphone

8) LCD (Liquid Crystal Display)

9) Transmit / Receive indicator : When receiving an incoming signal, the LED

indicator will light green, and while the PTT

button is pressed, the LED will light red.

These LED’s are used for backlighting as

well.

10)External speaker/mic jacks : Connect an optional speaker/mic or headset,

if desired. The internal mic and speaker will not

function when either one is connected.

2) Function display

Monitor Indicator: Icon appears when the monitor button is pressed and the channel

monitor function is activated.

Key Lock Indicator: Icon appears when the keypad is locked. This function

disables keys such as channel up/down and mode.

Signal Strength Indicator: Icon appears when a signal is being received. The Icon

consists of five bars to indicate the received signal level.

Beep Tone Indicator: Icon appears when beep tone confirmation tone is selected.

Icon disappears when tone is off.