User's Manual
Table Of Contents
- Front Cover
- Contents
- List of Figures
- List of Tables
- List of Code Listings
- Legal Disclaimer
- Regulatory Information
- Typographic Conventions
- Important Notice
- Hardware Setup
- 1 Introduction
- 2 Overview of the TTE-Switch Lab Space
- 3 Functional Description
- 4 Getting Started
- 5 State Machine
- 6 Configuring the TTE-Switch Lab Space
- 7 Diagnosis
- 8 Troubleshooting
- Appendix A Default Configuration
- Appendix B MIBs
- Glossary
- Bibliography
- Index
6. CONFIGURING THE TTE-SWITCH LAB SPACE
6 Configuring the TTE-Switch Lab Space
The device and network configuration files for the TTE-Switch Lab Space are created (see Section 6.1 on
the next page) and stored in the flash memory. The firmware maintains a file system on the flash device
to this end.
The device configuration files can be updated through TFTP only. A Python script lets the user prepare
the configuration files for the TFTP transfer. The Python script will add the header, CRC checksum, and
hash values that the firmware needs to check that the configuration files were transferred correctly before
they are stored.
Figure 8: Schematic overview of dataloading
NOTE
Any dataloading software that supports TFTP can be used on the host system to transfer configuration
files to the TTE-Switch Lab Space.
NOTE
Both the SWEcfg.tfpt and the Escfg.tftp configurations must be uploaded to obtain a working setup.
© TTTech Computertechnik AG 2019. All rights reserved.
Confidential and Proprietary Information
26
Document Number:
D-863-M-05-001