Installation & Assembly

Wave Roof

read first REVIEW BEFORE ASSEMBLY

• No tools are required for assembly

• For best results, follow the Steps

in the order they are presented

To assemble the CAGE BODY,

you will need these pieces:

To add the mesh body to the

BASE

, you will need these

pieces:

Set the grille into the base.

Push the tray into the base.

Set the assembled

mesh into the base.

Guide the lower loops

on the side panels into

the holes along the

rim of the base.

Guide the front and

back panels between

the outer rim and the

inner raised tab.

Attach the back panel to the right-side panel:

Start in the lower corner. Hook the right-side

panel onto the back panel.

Going up the seam, continue catching the

hooks around from the outside while keeping

the notched portion of the wire to the interior

of the cage.

Repeat the method for the other side-to-back

connection.

PAGE 1
Wave Roof read first REVIEW BEFORE ASSEMBLY • No tools are required for assembly • For best results, follow the Steps in the order they are presented 1 2 To assemble the CAGE BODY, you will need these pieces: To add the mesh body to the BASE, you will need these pieces: Attach the back panel to the right-side panel: Start in the lower corner. Hook the right-side panel onto the back panel.
PAGE 2
3 To add the ACCESSORIES, you will need these pieces: Assemble the two-piece cups. Carefully lift the snap-hinge cup doors and insert the cups. 4 To add the ROOF, you will need this piece: Catch the inner front-to-back wire of the roof under the loops on the side panel. Softly bend the roof mesh to catch the roof line onto the front and back panel loops. Finish by catching the roof onto the opposite side loops. Insert the perches on a vertical wire, resting on a horizontal wire for stability.