Assembly Instructions

1 Attach casters to legs of front (F)
and back (B) panels.
2
a
THIS STAGE IS EASIER WITH TWO PEOPLE.
Left side lower (L1) and right side lower (R1)
panels are interchangable. Channels on (L1)
and (R1) face interior of cage.
→
Have one person hold (F) panel upright while
second person installs (L1) and (R1) panels.
(L1) and (R1) panels have tabs at the bottom
corners. These tabs correspond to sleeves on
the legs of (F) and back (B) panels.
Slide the tab on bottom corner of left side
lower (L1) panel into the sleeve on the leg
of (F). Secure (L1) to (F) with long hex screw.
2
b
Following the same procedure, attach right side
lower (R1) panel to front (F) panel and attach (L1)
and (R1) panels to back (B) panel, inserting tabs
into sleeves and securing with long hex screws.
3After lower cage has been assembled, slide
the grille (G) and tray (T) into their tracks.
To keep the grille securely in place, a Safe-Clip
is included. Locate the short horizontal bar on
the panel under the grille, and centered directly
under the grille handle.
Hook the open-ends of the Safe-Clip onto the
short horizontal bar. Hook the upper part of the
Safe-Clip over the handle on the grille.
steps
4
a
THIS STAGE IS EASIER WITH TWO PEOPLE.
Left (L2) and right (R2) side panels are
interchangeable. For these instructions,
(R2) is the panel with the cup doors.
→ Make sure cup doors swing out (not into cage).
Side (L2) and (R2) panels slide into tracks
along (F) and (B) panel frames.
Three vertical wires on (L2) and (R2) panels
extend below lower horizontal wire. Align
wires with corresponding holes along top
surface of (L1) and (R1) side panels.
→ If extended wires are bent, straighten with
needle nose pliers.
4
b
Playtop (PT1) frame (shipped with Playtop Tray (PT2)
in place) fits over top of cage. Posts extend down
from corners and correspond with openings on (F) and
(B) panels.
Three vertical wires on (L2) and (R2) panels
extend above upper horizontal wire. Align wires with
corresponding holes along bottom of (PT1) frame.
Secure top to frame with short hex screws.
5Before assembling the full playtop unit, this is a good
time to add cup holders and stainless steel cups to
the side panel cup doors, and to install the longer
(24¾"L) wooden dowel perch.
F
F
L1
B
R1
G
T
L2
PT1
R2
B
PT2