Instructions / Assembly

In each corner there is an

indentation showing the

recommended fastener

location. Using a ¼" drill

bit to allow for expansion

and contraction, pre-drill

a hole in the center of

each indentation (Fig. 1).

Place the panel in the

desired location, mark the

four corners on the mounting

surface, and pre-drill using a

⁄

⁄8⁄

" bit (Fig. 2).

NOTE:

Be sure to allow an

⁄

⁄8⁄

between sheets for expansion

and contraction.

Place the screw cover over the

screw shank. Line the screw up

with the pre-drilled holes and

secure the sheeting in place.

Do not over-tighten the screw.

Snap screw cover in place to

hide the fastener (Fig. 3).

For each panel installed, you will need (4) #8 1½" long stainless

steel screws and screw covers (sold separately in matching colors).

To obtain and review a copy of the warranty please go to: BarretteOutdoorLiving.com/warranty.

You can also contact 1-877-279-4496 or write to Barrette Outdoor Living, 7830 Freeway Circle,

Middleburg Heights, Ohio 44130 to obtain a copy of the warranty.

Designer Series

PLEASE READ OWNER'S MANUAL COMPLETELY BEFORE INSTALLING

INSTALLATION INSTRUCTIONS

Fig. 1

Fig. 2

Fig. 3