Instructions / Assembly

ManualsBrandsTuffBilt ManualsFencingCascade 4 ft. W x 6 ft. H Black Standard-Duty Aluminum Straight Pre-Assembled Fence Gate

INSTALLATION INSTRUCTIONS

Aluminum Pre-Built Fence

For Standard & Heavy-Duty Series

ALUMFENCEA-BOM

Read all instructions prior to installing product.

Refer to manufacturers safety instructions when operating any tools.

To register your product, please visit:

www.tuffbilt.com

Summary of content (6 pages)

PAGE 1
ALUMFENCEA-BOM Aluminum Pre-Built Fence For Standard & Heavy-Duty Series INSTALLATION INSTRUCTIONS Read all instructions prior to installing product. Refer to manufacturers safety instructions when operating any tools. To register your product, please visit: www.tuffbilt.
PAGE 2
WARNING: • Improper installation of this product can result in personal injury. Always wear safety goggles when cutting, drilling and assembling the product. • Incorrect installation may cause harm to the product or individual. • Not pool code approved. NOTICE: • DO NOT attempt to assemble the kit if parts are missing or damaged. • DO NOT return the product to the store. For assistance or replacement parts call: 1-877.279.4496. BEFORE YOU BEGIN: Check your local zoning laws.
PAGE 3
Layout Installation: 1 Fig. 1 • Establish your fence line by staking out the areas you wish to enclose. Locate each point in which you will need an end, corner or gate post and mark it with a stake (Fig. 1). • For 6' sections using 2" posts: measure 723⁄4" from the center of an end point and mark with stake (Fig. 2). NOTE: • Installing on sloped terrain will reduce distance between posts. • If you are left with a space less than a full panel, the panel can be cut down to fit the space by using a hacksaw.
PAGE 4
Post Location: 3 Fig. 4 Measure the width of the fence panel (X) plus the width of the post (Y). This is the common center-to-center measurement (unless there is a cut-down panel) for post hole location (Fig. 4). X Y Post Installation: Dig the first two post holes. Hole size should be dug based on the following determination: Depth is determined by your local frost line measurements plus 6" for gravel/filler (Fig. 5).
PAGE 5
Panel/Post Installation 1 As the post is setting up, install the first fence panel. Insert the horizontal rails from the panel into the punched holes from the previously installed post. Place the rails as far into the post as they will go (Fig. 1). Fig. 1 Post Rail Rail Top view of post 2 Place the next required post into the dug hole, and slide the post onto the rails of the panel as far as possible. Fig. 2 Plumb and level the post and add concrete according to manufacturer's instructions.
PAGE 6
BARRETTE OUTDOOR LIVING 7830 FREEWAY CIRCLE MIDDLEBURG HEIGHTS, OHIO 44130 TEL: 877.279.4496 WWW.TUFFBILT.