Instructions / Assembly

Attach end post or corner post in position. See

separate post mounting instructions based on

individual situation.

Place 2" spacer blocks to support bottom rail

(Fig. 1).

Pre-install the rail adaptor (trim channel) into the

top, bottom, and both sides of the mid-rail

(Fig. 2). May need to use a rubber mallet to

completely set the trim channel in place.

Place bottom rail inside  rst post, resting it on the

2" spacer blocks (Fig. 3). Attach bottom rail using

two

⁄

⁄4⁄

" Hex Head screws (Fig. 4).

Back out the top screw so that the channel is

clean until in ll boards are installed (Fig. 5).

Installation For Composite Board In ll

(Surface mount shown; other options available)

⁄

⁄4⁄

Fig. 1

Fig. 3

Fig. 5

Fig. 4

Fig. 2

– Top Rail

– Mid Rail

– Bottom Rail

– Rail Adaptor