Manual

Page 1 of 2 - 2/21/2013 – Rev122006

INSTALLATION INSTRUCTIONS

Storage Trunk Part #025

Please read and fill out the enclosed warranty registration card to activate your warranty.

PARTS CHECKLIST

(4) 5/16 x 11/4” BOLTS (4) 5/16 NYLOCK NUTS

(12) 5/16” WASHERS RUBBER SEAL

TOOLS NEEDED

 Electric drill

 3/8” Drill bit

 Marker or pencil

 Knife

 ½” Socket and ratchet

 ½” Wrench

 Silicone sealant (Recommended)

PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLATION.

1. Install rubber seal on lid and check lock operation. (SEE FIGURE 1)

2. Place the trunk in the vehicle and center it making sure the tailgate will latch shut, and the seat will

fold and tumble(if applicable).

3. Using a marker or pencil, mark (4) spots through the 3/8” mounting holes in the trunk.

WARNING!

Make sure that there is nothing under the vehicle that will be damaged by the drill bit when drilling.

IN MOST VEHICLES THERE IS A GAS TANK UNDERNEATH THE REAR OF THE VEHICLE.

THE GAS TANK MAY HAVE TO BE LOWERED TO INSTALL THE MOUNTING BOLTS.

PLEASE CONSULT VEHICLE OWNERS MANUAL FOR INSTRUCTIONS ON LOWERING

THE GAS TANK.

4. Remove the trunk. Cut the carpet at the (4) marked holes. Using a 3/8” drill bit, drill out the (4)

marked spots in the floor.

5. It is recommended to use silicone sealant in any holes drilled in the vehicle to prevent rusting.

PAGE 1
INSTALLATION INSTRUCTIONS Storage Trunk Part #025 Please read and fill out the enclosed warranty registration card to activate your warranty. PARTS CHECKLIST (4) 5/16 x 11/4” BOLTS (4) 5/16 NYLOCK NUTS (12) 5/16” WASHERS RUBBER SEAL TOOLS NEEDED        Electric drill 3/8” Drill bit Marker or pencil Knife ½” Socket and ratchet ½” Wrench Silicone sealant (Recommended) PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLATION. 1. 2. 3.
PAGE 2
6. 7. Do not place the trunk in the vehicle until step 8. Install (4) 5/16 x 1 ¼” bolts with (4) 5/16” washers up from underneath in the holes in the vehicle. Fasten the bolts to the floor with (4) 5/16” washers and (4) 5/16” nylock nuts. (SEE FIGURE 2) Place the trunk back in the vehicle over the bolts fastened to the floor. Secure the trunk down to the bolts using (4) 5/16” washers, and (4) 5/16” nylock nuts.