Owner manual

Page 1 of 2 - 1/28/2008 – Rev011607

INSTALLATION INSTRUCTIONS

SECURITY LOCKBOX SET #020 AND #031

Please read and fill out the enclosed warranty registration card to

activate your warranty.

PARTS CHECKLIST

(8) 5/16” x 1-1/4” Bolts

(8) 5/16” Nylock Nuts (16) 5/16” Washers Rubber Seal Package

(6) #4 Nuts (6) #4 Washers (4) 5/16” Hole Plugs

TOOLS NEEDED

• Electric drill

• 3/8” Drill bit

• Marker or pencil

• Knife

• ½” Socket and ratchet

• ½” Wrench

• ¼” Wrench or Socket and Ratchet

• Silicone sealant (Recommended)

PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLATION.

This section applies to Part # 020 only

1. Bolt your speaker to the Tuffy box by placing the speaker cloth between the speaker and the box and

securing with fasteners provided with the speaker.

2. Route speaker wires through either the hole in the bottom of the box or the hole on the side of the box.

3. If you did not route the wires through the hole in the side of the box, plug the hole with the 5/16” plug

provided.

4. Connect speaker wires to speaker in accordance to the speaker installation manual.

PAGE 1
INSTALLATION INSTRUCTIONS SECURITY LOCKBOX SET #020 AND #031 Please read and fill out the enclosed warranty registration card to activate your warranty.
PAGE 2
5. 6. 7. Install rubber seal on lid and check lock operation. Place your Tuffy box in the vehicle on the wheel well, make sure placement of box does not interfere with the movement of the seat or convertible top. Using a marker or pencil, mark any (3) spots through the 3/8” mounting holes in the box. WARNING! Make sure that there is nothing under the vehicle that will be damaged by the drill bit when drilling. 8. Remove the box. Cut the carpet at the (4) marked holes.