User Manual

Page 1 of 4 - 4/15/2011 – Rev122006

INSTALLATION INSTRUCTIONS

TJ Console Part #040

Please read and fill out the enclosed warranty registration card to activate your warranty

SHIPMENT CONTENTS

Console Front shift lever console

Shipping Package

(2) ¼” Hole plugs (4) 5/16” Washers (2) 5/16 Locknuts (4) 6-32x5/8 Screws (2) ¼-20 x ½ Screws

(3) 1/4 x ¾” Self Tapping Screws (1) ¼ x 2 ¼” Self tapping screw (2) 5/16-18 X 1 ¼” Bolts

(1) Shift boot plate (1) Front console tray (1) 6 Speed shifter bracket Neoprene seal

Tools Needed

 (1) ½” wrench or ratchet, socket, and extension

 (1) ½” wrench

 (1) 3/8” wrench or ratchet, socket, and extension

 (1) ¼” Wrench

 Phillips head screwdriver, short

 3/8” drill bit

 Electric drill

 Silicone sealant (not necessary but recommended)

PAGE 1
INSTALLATION INSTRUCTIONS TJ Console Part #040 Please read and fill out the enclosed warranty registration card to activate your warranty.
PAGE 2
Installation 1. Please read all instructions before starting installation. NOTE: If you are installing this console in a 2001 or newer Jeep TJ (That came with the factory console with the sub-woofer cutout) this console may not completely cover the area on the floor where the carpet was cut at the rear of the console. An optional rear drink holder can be purchased separately and mounted after the console is installed to cover this area.
PAGE 3
ATTENTION: FREQUENT LUBRICATION IS NECESSARY ON THE LOCKING SYSTEM The pushbutton lock contains an “O” ring seal to protect the interior from dust and water. If this mechanism is not lubricated regularly it will become difficult to operate and it may not return to its home position preventing the key from operating the lock. If this happens simply pull up on the pushbutton to manually bring it back to its home position. Lubricate the pushbutton with a light lubricant such as silicone spray.
PAGE 4
FIGURE 7 6 Speed Shifter Bracket Tray Front Console Call (970) 564-1762 for Technical Support Page 4 of 4 - 4/15/2011 – Rev122006