User Manual

Page 1 of 3 - 1/28/2008 – Rev122006

INSTALLATION INSTRUCTIONS

REAR CARGO SECURITY LOCK-BOX #046

Please read and fill out the enclosed warranty registration card to activate your warranty.

PARTS CHECKLIST

(2) 8MM METRIC BOLTS (2) 5/16 WASHERS

(2) 3/8 X 1 BOLTS (4) 3/8 WASHERS (2) 3/8 NYLOCK NUTS

(2) 7/16 x 1 ¼ BOLTS (4) 7/16 WASHERS (2) 7/16 NYLOCK NUTS

FINGER PULL LEVER RUBBER SEAL

PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLATION.

ATTENTION!

• In some vehicles as a result of mounting the box on an uneven surface the lid may be offset and will not close

properly after the box is bolted down. To correct this, a spacer (not included) will need to be placed under the corner

of the box to compensate for the uneven mounting surface.

• It is recommended to use silicone sealant in any drilled holes to prevent any future rusting.

PAGE 1
INSTALLATION INSTRUCTIONS REAR CARGO SECURITY LOCK-BOX #046 Please read and fill out the enclosed warranty registration card to activate your warranty. PARTS CHECKLIST (2) 8MM METRIC BOLTS (2) 5/16 WASHERS (2) 3/8 X 1 BOLTS (4) 3/8 WASHERS (2) 3/8 NYLOCK NUTS (2) 7/16 x 1 ¼ BOLTS (4) 7/16 WASHERS (2) 7/16 NYLOCK NUTS FINGER PULL LEVER RUBBER SEAL PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLATION.
PAGE 2
1. Install rubber seal on lid and rear doorframe. (SEE FIGURE 1 AND FIGURE 2) 2. For packaging reasons the cargo box is shipped without the finger pull lever installed on the rear door. The pushbutton will have to be removed and reinstalled with the finger pull lever. Before removing the pushbutton make sure it is in the unlocked position and observe the cam location so it can be remounted in the same position.
PAGE 3
GENERAL MOUNTING INSTRUCTIONS 1. Place cargo box in the bed. 2. Mark any (4) holes for drilling using the box mounting holes 1 through 5 as a template. (Select the holes that will not interfere with anything under the vehicle and will be easy to access with the wrenches.) (SEE FIGURE 4) WARNING! Make sure that there is nothing under the vehicle that will be damaged by the drill bit when drilling. 3. Remove cargo box and drill out the (4) marked holes with a ½” drill bit. 4.