User Manual

Page 3 of 3 - 1/28/2008 – Rev122006
GENERAL MOUNTING INSTRUCTIONS
1. Place cargo box in the bed.
2. Mark any (4) holes for drilling using the box mounting holes 1 through 5 as a template. (Select the holes that will not
interfere with anything under the vehicle and will be easy to access with the wrenches.) (SEE FIGURE 4)
WARNING!
Make sure that there is nothing under the vehicle that will be damaged by the drill bit when drilling.
3. Remove cargo box and drill out the (4) marked holes with a ½” drill bit.
4. Secure the cargo box down using both (2) 7/16 x 1 ¼ bolts, (2) 7/16 nuts, (4) washers and also (2) 3/8 x 1 bolts, (2)
nuts, and (4) washers in any combination.
ATTENTION:
FREQUENT LUBRICATION IS NECESSARY ON THE LOCKING SYSTEM
The pushbutton lock contains an “O” ring seal to protect the interior from dust and water. If this mechanism is not
lubricated regularly it will become difficult to operate and it may not return to its home position preventing the key from
operating the lock. If this happens simply pull up on the pushbutton to manually bring it back to its home position.
Lubricate the pushbutton with a light lubricant such as silicone spray. The pushbutton may have to be periodically
disassembled and cleaned.
Call [phone] for Technical Support