User Manual

Page 1 of 2 - 1/28/2008 – Rev122006

INSTALLATION INSTRUCTIONS

Samurai Security Console Part # 052

Please read and fill out the enclosed warranty registration card to activate your warranty.

Tools Needed

 Marking Pencil or Pen

 ½ ” Socket and Ratchet

 ½ ” Wrench

 5/16” Wrench

 3/8 ” Wrench

 Drill and 3/8” drill bit (1/8” bit recommended for pilot hole)

Shipping Package

(4)5/16 x 1 ¼” Grade 8 Bolts (2) 10-32 Unslotted Machine screws

(4) 5/16” Locknuts (2)10-32 Locknuts (8)5/16” Washers (2)#10 Washers (2) Hole Plugs

Mounting Directions

1. Attach the drink holder to either the

rear of the console or the front of the

console using (2) 10-32x ½” screws,

(2) #10 locknuts, and (4) #10

washers. Additional drink holders for

the rear can be purchased

separately, Tuffy part #034. NOTE

Clearance between the emergency

brake and a front mounted drink

holder is close and the operator

might hit their hand.

PAGE 1
INSTALLATION INSTRUCTIONS Samurai Security Console Part # 052 Please read and fill out the enclosed warranty registration card to activate your warranty. Tools Needed Marking Pencil or Pen ½ ” Socket and Ratchet ½ ” Wrench 5/16” Wrench 3/8 ” Wrench Drill and 3/8” drill bit (1/8” bit recommended for pilot hole) Shipping Package (4)5/16 x 1 ¼” Grade 8 Bolts (2) 10-32 Unslotted Machine screws (4) 5/16” Locknuts (2)10-32 Locknuts (8)5/16” Washers (2)#10 Washers Mounting Directions 1.
PAGE 2
. Pull the emergency brake all the way up and place the console between the seats in the final mounting position desired. NOTE: If the emergency brake pulls up more than about 45 degrees it should be adjusted by a qualified professional prior to installation of your Tuffy console. 3. Mark the floor directly under the (4) 3/8” mounting holes in the Tuffy console. 4. Remove the console. Cut holes in the carpet where the marks are (from step #3). 5.