User Manual

Page 1 of 3 - 1/28/2008 – Rev122006

INSTALLATION INSTRUCTIONS

Rear Cargo Drawer – Part #058 and #063

Please read and fill out the enclosed warranty registration card to activate your warranty.

Shipping Package

• (4) 7/16 x 1 ¼ Bolts

• (4) 7/16 Nylock Nuts

• (4) 7/16 Washers

• (2) 8MM Metric Bolts

• (2) 5/16 Washers

• (2) ¼” Serrated flange nuts

• (4) ½” Hole Plugs

• (1) Drawer Handle

NOTICE! DRAWER WILL HAVE TO BE REMOVED FOR INSTALATION

INSTRUCTIONS FOR REMOVING DRAWER

Before attempting to install your new Tuffy Drawer, it is necessary to remove the drawer from the

body. To do this, pull the drawer out as far as it can go then locate the small black plastic stops

visible on the ball bearing drawer slides. One of the black stops will need to be deactivated by

pressing down and the other one pulled up. Be careful not to break plastic stops. While deactivating

the stops pull the drawer out and the slides will separate. When you are finished installing your

drawer, line up the slides and push the drawer back in.

WARNING: If you are bolting your drawer through the side holes, be sure not to overtighten the bolts

which can cause the top of the enclosure to “flex” downward. It may be necessary to install a spacer

between the side of the drawer and the vehicle sidewall to prevent this bowing.

Mounting Directions

• Insert the studs on the drawer handle

into the corresponding holes in the

drawer. Secure handle with the ¼” nuts.

• If you are not going to use the side

mounting holes, use the hole plugs

provided.

• If you have any Rear Cargo Drawer

accessories (Divider or Riser Kits), refer

to their individual instructions for

installation

• If you do not have any Rear Cargo

Drawer accessories and would like to get

some, call your nearest Tuffy Security

Products dealer or call Tuffy direct. The

divider kit allows you to neatly

compartmentalize while the riser kit

allows you to store items such as the soft

doors under the drawer.

PAGE 1
INSTALLATION INSTRUCTIONS Rear Cargo Drawer – Part #058 and #063 Please read and fill out the enclosed warranty registration card to activate your warranty.
PAGE 2
CJ-7 MOUNTING INSTRUCTIONS 1. Take out rear seat by removing seat-mounting bolts on the two front seat brackets and along the back seat mounting bracket. 2. Place cargo box in Jeep bed. 3. Using the (2) 7/16 x 1 ¼ bolts and washers secure the cargo box down through mounting holes indicated in the drawing WARNING! Make sure that there is nothing under the vehicle that will be damaged by the drill bit when drilling. Before drilling any holes make sure the drawer placement allows the tailgate to close! 4.
PAGE 3
ATTENTION: FREQUENT LUBRICATION IS NECESSARY ON THE LOCKING SYSTEM The pushbutton lock contains an “O” ring seal to protect the interior from dust and water. If this mechanism is not lubricated regularly it will become difficult to operate and it may not return to its home position preventing the key from operating the lock. If this happens simply pull up on the pushbutton to manually bring it back to its home position. Lubricate the pushbutton with a light lubricant such as silicone spray.