User Manual

Page 1 of 3 - 3/29/2010 – Rev122006

OPERATING INSTRUCTIONS

089 COMBO LOCK MOUNTED IN LATCHRTC90CMBO

Call (970) 564-1762 for Technical Support

Instructions for changing the combination

Attention: The combination pushbutton lock is typically shipped from the factory with either no code entered yet

or “12345” and will need to be reset by the customer. Alternative pre-programmed code is ________________

1. Selecting your combination

1.1. Please look at the front of the combination lock. There are buttons numbered 1 through 0. There is also an

OPEN lever and a CLEAR button. (See Figure 1)

1.2. Select your own combination and keep the combination in a safe place.

1.3. For best results, select between four and seven numbers in your combination. Each number can only be used

one time. Do not use number combinations that can be easily guessed.

Figure 1

2. Setting your combination

WARNING: Improperly setting the combination is not covered under the warranty. Do not disassemble the

lock. Doing so voids the warranty.

2.1. Press on the CLEAR to reset the combination lock. (See Figure 1)

2.2. Looking through the slots in the latch cover on the inside of the drawer you will see ten numbered buttons with

arrows. (These are actual upside down the way the latch is installed) These numbers correspond to the

numbered button on the front of the lock. (See Figure 2 and 3)

PAGE 1
OPERATING INSTRUCTIONS 089 COMBO LOCK MOUNTED IN LATCHRTC90CMBO Call (970) 564-1762 for Technical Support Instructions for changing the combination Attention: The combination pushbutton lock is typically shipped from the factory with either no code entered yet or “12345” and will need to be reset by the customer. Alternative pre-programmed code is ________________ 1. Selecting your combination 1.1. Please look at the front of the combination lock. There are buttons numbered 1 through 0.
PAGE 2
Figure 2 2.3. The arrows on the screws are pointing in the direction which the previous codes were set to. (See Figure 3) IMPORTANT: Open knob must be in LOCKED position before the code can be changed. 2.4. Use a small screwdriver to rotate the arrows. For each number in your combination, apply light pressure and rotate a half turn so that the arrow points correctly (SET ON) and snaps up. Be sure to reset all the arrows to SET OFF before entering the new combination. (See Figure 3) 2.5.
PAGE 3
. Testing your combination before closing the drawer. Please note: This product is equipped with a clutch mechanism to protect if from forced entry. Do not be alarmed if the OPEN lever turns even if the correct combination has not been entered. 3.1. Do not close the drawer. Press on the latch mechanism on the inside of the box to engage the latch. 3.2. Make sure OPEN lever is in home position. If not, turn OPEN lever counterclockwise until it’s in the home position.