Instruction Manual

Page 2 of 2 - 1/28/2008 – Rev122006
LARGE WASHER LOCK SPACER
3. Slide the lock (with the large washer lock spacer if applicable) onto the finger pull or the dust cover.
4. Insert the assembly back into the Tuffy box.
5. Tighten the lock down with the large lock-mounting nut.
6. Check lock operation.
CAM-LOCK OPERATION
3. TUBULAR KEYED CAM-LOCK
1. Remove the cam-lock by loosening the cam mounting nut, the lock washer, the cam, and the large lock-mounting nut.
2. Slide the lock onto the finger pull or the dust cover.
3. Insert the assembly back into the Tuffy box.
4. Re-install the hardware with the new ¼” spacing washer (supplied) before the cam, lock-washer, and cam mounting
nut.
TUBULAR LOCK ASSEMBLY WITH ¼” SPACING WASHER
5. Tighten the lock down with the large lock-mounting nut.
6. Check lock operation.
¼” Spacing Washer
Cam
Lock Washer
Finger Pull
Lock Mounting Nut
Cam Mounting Nut