Manual

Page 1 of 2 - 10/27/2010 – Rev122006

INSTALLATION INSTRUCTIONS

JK Conceal Carry Security Drawer #247

Please read and fill out the enclosed warranty registration card to activate your warranty.

PARTS CHECKLIST

#8.2 - 5/16 x 1” BOLT #8.1 - 5/16 NYLOCK NUT #8.3 - 5/16” WASHER

(2) Zip ties

TOOLS NEEDED

 Electric drill (Optional)

 18MM Socket and Ratchet

 ½” Socket and ratchet (Optional)

 3/16” Allen wrench (Optional)

 Marker or pencil

 Knife

 2011+ JK only, T-30 torx, Pliers & a flat head screwdriver

PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLATION.

Warning! Do not operate the vehicle without the drawer locked shut. If left unlocked

normal vehicle movements while driving could cause the drawer to open creating an

unsafe situation.

Note: To remove the drawer from the enclosure, pull the drawer out as far as it can go then

locate the small black plastic stops visible on the ball bearing drawer slides. One of the black

stops will need to be deactivated by pressing down and the other one pulled up. Be careful not to

break these plastic stops. While deactivating the stops push the center slide section back into the

drawer enclosure off of the front slide section attached to the drawer until they are separated. To

reinstall, line up the slide sections and push the drawer in gently, do not force it or it can be

damaged.

2011+ JK Additional instructions - Remove harness mounting plate and secure harness to seat base.

 Under the driver’s seat remove the OEM harness mounting plate using a T-30 torx.

 Remove the wire harness and connector plug from the OEM mounting plate. The plastic attachment

fastener on the wire harness toward the rear of the vehicle can be squeezed together and popped out

with pliers. The plastic attachment fastener toward the front of the vehicle on the wire harness

connector plug can be removed by squeezing the wafers with pliers while prying it out with a flat head

screwdriver . If these break off it is not a problem, they will not be reused.

 Zip tie the wire harness cable, just behind the harness plug toward the rear of the vehicle, to the holes

in the lower OEM seat slide bracket where the OEM torx screws fastening the OEM mounting plate

were removed.

PAGE 1
INSTALLATION INSTRUCTIONS JK Conceal Carry Security Drawer #247 Please read and fill out the enclosed warranty registration card to activate your warranty. PARTS CHECKLIST #8.2 - 5/16 x 1” BOLT #8.1 - 5/16 NYLOCK NUT #8.
PAGE 2
1. 2. Remove the original seat mounting bolts #8.4 holding the front of the Drivers side seat to the body. (See Figure 1) Insert the drawer in the mounted position. Make sure the right side seat bracket #8.6 is under the mounting flange on the Tuffy drawer and the left side seat bracket #8.7 is on top of the mounting flange on the drawer as illustrated. (See Figure 1) OPTIONAL SECURITY STEP WARNING! - Make sure that there is nothing under the vehicle that will be damaged by the drill bit when drilling.