Instructions / Assembly

12
TROUBLE SHOOTING:
NOITCERROCESUACMELBORP
LCD screen will not
light up
Grill is
not getting
hot enough
Pellets will not light
Grill is getting too
hot
Temperature
uctuations
1. Grill is not plugged in.
2. The fuse is blown.
3. Check that the GFCI outlet has not been
tripped.
4. Control knob is in the “OFF” position.
1. Make sure the grill is plugged into a working
power source. Check and make sure wire
connections are properly connected.
2. Check the fuse and see if it has blown and
needs to be replaced. Use 5 Amp Fuse.
3. Reset GFCI outlet.
4. Control knob is still in the “OFF” position.
Push in the control knob to 175° F to start-
up the grill. The LCD screen should turn on.
1. Adjust temperature control knob on
temperature controller.
2. Avoid the temptation to check food too
often.
3. Verify that there are pellets in pellet
hopper.
4. Fire goes out at lower setting.
1. Turn up heat on the control knob.
2. Opening the hood allows heat to escape
and causes the temperature to vary
drastically from the set temperature.
3. Add pellets and allow sufficient time for the
pellets to travel from the pellet hopper to
4. Excess ash. Remove all unburned pellets
clean-out.
CAUTION! ASSURE THAT THE GRILL
IS COLD TO AVOID A FIRE FROM HOT
ASH.
1. Auger not primed.
2. Auger is jammed.
3. Ignitor has failed.
1. This is normal due to the air pressure
inside the grill. The amount of smoke can
vary depending on cooking conditions.
2. Unplugged grill too soon.
by wind, air temperature, improper use, or lack of grill maintenance.
or anytime the hopper is emptied, allow
the auger tube to fully load with pellets to
ensure proper lighting of the grill. Follow
Initial Lighting Instructions.
Turn on the grill to 180* F and inspect the
auger.
3. Ignitor needs to be replaced. Contact our
Customer Service dept. for a replacement
part. Follow Manual Start-Up Procedure
to continue use of the grill.
1. This condition will not affect cooking.
2. Once the grill is turned off the fan will
continue to run for 5 minutes. If you do not
allow the grill to go through the cool down
auger tube.
Smoke comes out
of pellet hopper
1. Adjust temperature control 1. Reduce heat by reducing the selected
temperature setting.