Instructions / Assembly
4. Turn assembly upright and push
tapered locks (B). Note: Make sure
the lip of shelf (A) is facing down
and the levelers (F) on bottom
5. Repeat steps 2-4 for the second
shelf (A).
6. Screw top pole (C) onto bottom pole (D). Hand tighten.
7-1 Repeat steps 2-4 for the remaining shelves (A).
Refer to image 7-1 for the assembled unit of stationary option.
ASSEMBLY INSTRUCTIONS
1. Stationary Option: Screw each
feet leveler (F) into the bottom of
each bottom pole (D). Turn clock-
wise to screw in place.
Mobile Option: Screw each wheel
(E) into the bottom of each bottom
pole (D). Turn clock-wise to screw
in place.
3. Rest shelf (A) on its side, then
insert the bottom poles (D) through
the corner holes of the shelf (A).
9
1
B
3
D
D
D
D
A
4
5
C
C
C
C
PACKAGE CONTENTS Attention:Please install it with 2 people !
Shelfx 6
B
x 48 +2 extra
E
Wheel
(2 locking, 2 non-locking)
(for mobile option)
x 4
Feet Leveler
(for stationary option)
F
x 4
6-TIER HEAVY-DUTY SHELVING
XLB-1848
A
D
x4 Bottom
Pole(with threaded insert preassembled)
x 4 Top Pole
(with pole cap and pole connector preassembled)
C
2. With the tapered end facing up,
snap the two halves of a tapered
lock (B) at the desired height on
bottom pole (D). Repeat for the
remaining bottom poles (D),
making sure the tapered locks (B)
are installed at the same grooved
line on each bottom pole (D).
2
B
D
MOBILE
STATIONARY
E
F
D
D
B
D
7-2. Repeat steps 2-4 for the remaining shelves (A).
Refer to image 7-2 for the assembled unit of mobile option.
Warning:
Maximum weight capacity per shelf
is 1000lbs when equally distributed on
feet levelers.
Maximum entire unit weight capacity
is 600lbs when equally distributed on
casters.
Failure to follow these instructions may
result in serious injury or death of
yourself and people around you．
Some of the part are heavy and/or has
shape edge, please install it carefully to
avoid hurt you and people around you.
Caution:
Do not stand on or climb on the shelving unit.
Place heavier items on lower shelves
and lighter ones on top shelves.
G
x 20
Black plastic spacer
(NOTE: Discard the black plastic spacers I.
These between each shelf are only for packing
purpose , not for assembling.)
Attention: The wheel (E) must be
fully screwed to the botton pole
(D) by wrench
Attention：The tapered must be fixed to the groove
on the pole, and make sure the tapered does not
slip before installing the shelf