User's Manual

© 2002 Tunstall Group Ltd. Telecom 4000 User Guide 31
This equipment complies with Part 68 of the FCC rules and
the requirements adopted by the ACTA. On the base of this
equipment is a label that contains, among other information,
a product identifier in the format US:AAAEQ##TXXXX. If
requested, this number must be provided to the telephone
company.
Universal Service order Code (USOC): RJ11C
A plug and jack used to connect this equipment to the premises
wiring and telephone network must comply with the applicable
FCC Part 68 rules and requirements adopted by the ACTA. A
compliant telephone cord and modular plug is provided with
this product. It is designed to be connected to a compatible
modular jack that is also compliant. See installation instructions
for details.
Ringer Equivalence Number (REN): 0.4
The REN is used to determine the number of devices that may
be connected to a telephone line. Excessive RENs on a
telephone line may result in the devices not ringing in response
to an incoming call. In most but not all areas, the sum of RENs
should not exceed five (5.0). To be certain of the number of
devices that may be connected to a line, as determined by the
total RENs, contact the local telephone company. For products
approved after July 23, 2001, the REN for this product is part
of the product identifier that has the format
US:AAAEQ##TXXXX. The digits represented by ## are the
REN without a decimal point (e.g., 04 is a REN of 0.4). For
earlier products, the REN is separately shown on the label.
If this equipment (Telecom 4000) causes harm to the telephone
network, the telephone company will notify you in advance
that temporary discontinuance of service may be required. But
if advance notice isn't practical, the telephone company will
notify the customer as soon as possible. Also, you will be
advised of your right to file a complaint with the FCC if you
believe it is necessary.
The telephone company may make changes in its facilities,
equipment, operations or procedures that could affect the
operation of the equipment. If this happens the telephone
company will provide advance notice in order for you to make
necessary modifications to maintain uninterrupted service.
This equipment (Telecom 4000) contains no user servicable
parts. If trouble is experienced with this equipment (Telecom
4000), for repair or warranty information, please contact
Tunstall Canada Inc. Tel [phone]. If the equipment is
causing harm to the telephone network, the telephone
company may request that you disconnect the equipment until
the problem is resolved.
Connection to party line service is subject to state tariffs.
Contact the state public utility commission, public service
commission or corporation commission for information.
If your home has specially wired alarm equipment connected
to the telephone line, ensure the installation of this equipment
(Telecom 4000) does not disable your alarm equipment. If you
have questions about what will disable alarm equipment,
consult your telephone company or a qualified installer.
When programming emergency numbers and (or)
making test calls to emergency numbers:
1Remain on the line and briefly
explain to the dispatcher the reason
for the call.
2Perform such activities in the off-
peak hours, such as early morning
or late evenings.
Alarm dialing equipment must be able to seize the telephone
line and place a call in an emergency situation. It must be able
to do this even if other equipment (telephone, answering
system, computer modem, etc.) already has the telephone line
in use. To do so, alarm dialing equipment must be connected
to a properly installed RJ31X jack that is electrically in series
with and ahead of all other equipment attached to the same
telephone line. Proper installation is depicted in the figure
below. If you have any questions concerning these instructions,
you should consult your telephone company or a qualified
installer about installing the RJ31X jack and alarm dialing
equipment for you.
Federal Communications Commission (FCC) notices