Operation Manual

Platinum by Tunturi 8 4 in 1 Strength Station Owner's Manual
Pre-Assembling Instructions
NOTE: It is important to position the Upper Body and the Lower Body
Stations accordingly. Make sure they are approximately 5 foot 1 inch
apart by measuring from the inside of the rear base on each machine.
Also Make sure the rear base on each machine are in line with each other
across the back. This is important for connecting the two machines via the
Cable Cross Over as seen in step 3. This will help to insure all of the com-
ponents on the 4 in 1 Strength Station line up smoothly and will help to
make the installation process effortless.
Approx. 5’ 1”
Platinum Lower Body Station
Platinum Upper Body Station
Platinum by Tunturi 16 4 in 1 Strength Station Owner's Manual
• Adjust cables to proper tension from any of the locations shown below.
Note: All cables with threaded adjustable ends must have at least 1/2” of the threads threaded in to its counter-
part. It is very important that the 1/2” Jam Nut be wrench tightened to the counterpart to ensure that the threaded
adjustable end of the cable does not back out of its counterpart.
• Note: If the top plate raises off of the second plate in the weight stack, then the cable tension is too tight. You will need to take
some of the tension out to lower the Top plate flush with the second plate.
Cable Adjustments
This bolt can be
positioned in any one of
the three optional holes
to account for any slack
in the cable. Refer to
Step 5.
Fine adjustments to cable
tension can be made here.
At least 1/2” of the threads
should be threaded in to
the top weight plate. It is
very important to tighten
the jam nut after
adjustments.
www.tunturi.com 17 4 in 1 Strength Station Owner’s Manual
• Clean guide rods with a lint-free cloth and apply a thin layer of silicon lubricant to each guide rod. This will ensure a glass smooth
performance from your weight stack.
Weight Stack Decals:
Guide Rod Lubrication:
200lb Stack (Standard)
Final Assembly and Troubleshooting
PG6251說明書101025---001 拚版用-12.indd 15-16 2010/11/3 20:38:25