Operation Manual

34 35
Bike 1.0 - OWNER’S MANUAL ENGLISH
HANDLEBAR
Attach the cable coming from the frame tube to the
connector at the bottom of the handlebar.
Ensure that the joint is securely locked by gently pulling the
wire. Thread the wire carefully inside the frame tube and
push the handlebar support tube into place inside the
frame tube so that the fastening screws are on the front of
the tube.
CONSOLE
1. Connect the cables from the handlebar to the
corresponding connectors of the console. Insert the
connected cables into the console, but make sure they
are not damaged when the console is attached.
2. Place the console in position at the end of the
handlebar support tube and attach the console using two
mounting screws.
SEAT
Loosen the seatholder locking screw and turn the upper
locking lever so that it is aligned with the equipment.
Place the seat into position on the grooves of the lower
locking lever. Turn the upper locking lever towards the top
of the seat rails and lock the seat by tightening the locking
screw.
Bike 1.0_MANUAL.indd 35 9/12/2012 3:03:25 PM