Safety Information

Report No.: AGC04298180501ES01
Page 20 of 51
EN 60950-1
Clause
Requirement – Test
Result – Remark
Verdict
Method 2, application of all of simulated fault
condition tests
N
4.7.2
Conditions for a fire enclosure
See appended table 1.5.1
P
4.7.2.1
Parts requiring a fire enclosure
N
4.7.2.2
Parts not requiring a fire enclosure
Supplied by approved AC adaptor
complied with LPS
P
4.7.3
Materials
P
4.7.3.1
General
P
4.7.3.2
Materials for fire enclosures
See appended table 1.5.1
P
4.7.3.3
Materials for components and other parts outside
fire enclosures
N
4.7.3.4
Materials for components and other parts inside
fire enclosures
Internal components except small
parts are V-2 or better.
P
4.7.3.5
Materials for air filter assemblies
No air filter assemblies
N
4.7.3.6
Materials used in high-voltage components
No high voltage components.
N
5
ELECTRICAL REQUIREMENTS AND SIMULATED ABNORMAL CONDITIONS
P
5.1
Touch current and protective conductor current
N
5.1.1
General
N
5.1.2
Equipment under test (EUT)
N
5.1.2.1
Single connection to an a.c. mains supply
N
5.1.2.2
Redundant multiple connections to an a.c. mains
supply
N
5.1.2.3
Simultaneous multiple connections to an a.c.
mains supply
N
5.1.3
Test circuit
N
5.1.4
Application of measuring instrument
N
5.1.5
Test procedure
N
5.1.6
Test measurements
N
Test voltage (V) ................................................... :
N
Measured touch current (mA) .............................. :
N
Max. allowed touch current (mA) ......................... :
N
Measured protective conductor current (mA) ...... :
N
Max. allowed protective conductor current (mA) . :
N
5.1.7
Equipment with touch current exceeding 3.5 mA :
N
5.1.7.1
General ................................................................. :
N
5.1.7.2
Simultaneous multiple connections to the supply
N