Safety Information

ManualsBrandsTUOSHI ManualsComputers & AccessoriesUnlocked 4G LTE Router with SIM Card Slot -Wireless WiFi CPE, Mobile Hotspot, Wireless WiFi Router, Support T-Mobile and ATT (4 Antenna)

Report No.: AGC04298180501ES01

Page 35 of 51

EN 60950-1

Clause

Requirement – Test

Result – Remark

Verdict

Zx.4.3 Wireless listening devices

In wireless mode:

- with any playing and transmitting device playing the fixed

programme simulation noise described in EN 50332-1; and

- respecting the wireless transmission standards, where an air

interface standard exists that specifies the equivalent

acoustic level; and

- with volume and sound settings in the listening device (for

example built-in volume level control, additional sound

feature like equalization, etc.) set to the combination of

positions that maximize the measured acoustic output for the

abovementioned programme simulation noise, the acoustic

output LAeq,T of the listening device shall be ≤ 100 dBA.

NOTE An example of a wireless listening device is a Bluetooth

headphone.

Zx.5 Measurement methods

Measurements shall be made in accordance with EN 50332-1

or EN 50332-2 as applicable. Unless stated otherwise, the

time interval T shall be 30 s.

NOTE Test method for wireless equipment provided without

listening device should be defined.

2.7.1

Replace the subclause as follows:

Basic requirements

To protect against excessive current, short-circuits and earth

faults in PRIMARY CIRCUITS, protective devices shall be

included either as integral parts of the equipment or as parts of

the building installation, subject to the following, a), b) and c):

a) except as detailed in b) and c), protective devices

necessary to comply with the requirements of 5.3 shall be

included as parts of the equipment;

b) for components in series with the mains input to the

equipment such as the supply cord, appliance coupler, r.f.i.

filter and switch, short-circuit and earth fault protection may be

provided by protective devices in the building installation;

c) it is permitted for PLUGGABLE EQUIPMENT TYPE B or

PERMANENTLY CONNECTED EQUIPMENT, to rely on

dedicated overcurrent and short-circuit protection in the

building installation, provided that the means of protection, e.g.

fuses or circuit breakers, is fully specified in the installation

instructions.

If reliance is placed on protection in the building installation,

the installation instructions shall so state, except that for

PLUGGABLE EQUIPMENT TYPE A the building installation

shall be regarded as providing protection in accordance with

the rating of the wall socket outlet.

2.7.2

This subclause has been declared „void‟.

3.2.3

Delete the NOTE in Table 3A, and delete also in this table the

conduit sizes in parentheses.