Safety Information

ManualsBrandsTUOSHI ManualsComputers & AccessoriesUnlocked 4G LTE Router with SIM Card Slot -Wireless WiFi CPE, Mobile Hotspot, Wireless WiFi Router, Support T-Mobile and ATT (4 Antenna)

Report No.: AGC04298180501ES01

Page 40 of 51

EN 60950-1

Clause

Requirement – Test

Result – Remark

Verdict

ZB ANNEX (normative) SPECIAL NATIONAL CONDITIONS (EN)

3.2.1.1

In Denmark, supply cords of single-phase equipment having a

rated current not exceeding13 A shall be provided with a plug

according to the Heavy Current Regulations, Section 107-2-

D1.

CLASS I EQUIPMENT provided with socket-outlets with earth

contacts or which are intended to be used in locations where

protection against indirect contact is required according to the

wiring rules shall be provided with a plug in accordance with

standard sheet DK 2-1a or DK 2-5a.

If poly-phase equipment and single-phase equipment having a

RATED CURRENT exceeding 13 A is provided with a supply

cord with a plug, this plug shall be in accordance with the

Heavy Current Regulations, Section 107-2-D1 or EN 60309-2.

3.2.1.1

In Spain, supply cords of single-phase equipment having a

rated current not exceeding 10 A shall be provided with a plug

according to UNE 20315:1994.

Supply cords of single-phase equipment having a rated

current not exceeding 2,5 A shall be provided with a plug

according to UNE-EN 50075:1993.

CLASS I EQUIPMENT provided with socket-outlets with earth

contacts or which are intended to be used in locations where

protection against indirect contact is required according to the

wiring rules, shall be provided with a plug in accordance with

standard UNE 20315:1994.

If poly-phase equipment is provided with a supply cord with a

plug, this plug shall be in accordance with UNE-EN 60309-2.

3.2.1.1

In the United Kingdom, apparatus which is fitted with a

flexible cable or cord and is designed to be connected to a

mains socket conforming to BS 1363 by means of that flexible

cable or cord and plug, shall be fitted with a „standard plug‟ in

accordance with Statutory Instrument 1768:1994 - The Plugs

and Sockets etc. (Safety) Regulations 1994, unless exempted

by those regulations.

NOTE „Standard plug‟ is defined in SI 1768:1994 and

essentially means an approved plug conforming to BS 1363 or

an approved conversion plug.

3.2.1.1

In Ireland, apparatus which is fitted with a flexible cable or

cord and is designed to be connected to a mains socket

conforming to I.S. 411 by means of that flexible cable or cord

and plug, shall be fitted with a 13 A plug in accordance with

Statutory Instrument 525:1997 - National Standards Authority

of Ireland (section 28) (13 A Plugs and Conversion Adaptors

for Domestic Use) Regulations 1997.

3.2.4

In Switzerland, for requirements see 3.2.1.1 of this annex.

3.2.5.1

In the United Kingdom, a power supply cord with conductor

of 1,25 mm2 is allowed for equipment with a rated current over

10 A and up to and including 13 A.