Manual

ManualsBrandsTurbo Action ManualsCar70003B CHEETAH SCS Shifter

Part #70003B 1 10/93,9/98,2/01,5/06

1535 Owens Road, Jacksonville, FL 32218

Phone (904) 741-4850***FAX (904) 741-4853

WWW.turboaction.com

The Turbo Action Cheetah Competition SCS Shifter is the finest competition shifter built today! If

installed properly, it will last for many years with flawless performance.

This shifter will work with stock pattern and/or reverse pattern valve bodies.

CHEETAH SCS SHIFTER

Part #70003B

Fits: Ford C4 (1964-Up) & Ford C6 (1966-Up)

(Note: Will not fit any four-speed automatic transmissions)

Parts Breakdown

1 - Ford Control

1 - 70080B Gear Position Indicator Decal (PRN123)

1 - 70081B Gear Position Indicator Decal (PRN321)

1 - 70102 Special Five Foot Cable (On Shifter)

1 - 70200A Control Switch 10AMP (On Shifter)

1 - 70211 Park/Neutral Start Switch Kit (Ford & GM Only)

Includes:

1 - 70210A Switch

1 - 70049 Switch Mounting Bracket

2 - 70154 Nylon Rollers (On Shifter)

2 - 70155 Clevis Pins (On Shifter)

2 - 70136A Cotter Pins (On Shifter)

1 - 70139 Switch Nut

1 - 70222 Installation Kit

Includes:

1 - Set of Instructions

1 - 70034 C4 Shift Lever

1 - 70035 C6 Shift Lever

1 - 70036-1 Shaft for C4 & C6 Shift Lever

1 - 70054 Ford Pan Cable Bracket

1 - 70130S Pivot

1 - 70136B Hairspring Cotter

1 - 70140 Cable Clamp (U-Shaped)

1 - 70141A Shim Block

2 - 70147 Pan Bolts 5/16-18 X 3/4” (7/16” Head)

2 - 70151 Cable Clamp Hex Nuts (1/4-28 Nylon Lock)

1 - 70160 Nut for Shaft #70036-1

1 - 70162 Internal Tooth Lock Washer for Shaft #70036-1

1 - 00255-1 Set Screw

2 - 70134 3/8” Flat Washers

2 - 50101 Contingency Decals

70003B

Summary of content (9 pages)

PAGE 1
70 3 00 B 1535 Owens Road, Jacksonville, FL 32218 Phone (904) 741-4850***FAX (904) 741-4853 WWW.turboaction.
PAGE 2
FIRST, READ INSTRUCTIONS CAREFULLY, THEN PROCEED WITH EACH STEP INDIVIDUALLY. Use Lifter Only To Go into Reverse. The unique reverse lockout system requires only that you lift the reverse lockout mechanism with your two fingers while placing into reverse with the same hand. Note: Do NOT lift mechanism for any other shift! CAUTION: In a race it is imperative that the forward gears be precise in relation to the shifter.
PAGE 3
STEP # 7: Before removing valve body TAKE NOTE how the small passing gear linkage on the outside of the case, driver’s side, moves back and forth. Note how it springs back smoothly, no bind. STEP # 8: Take 7/16” socket and remove the eight or nine bolts which hold the valve body in place. Carefully lower valve body. STEP #9: The valve body is a very intricate part of the transmission, therefore requires a clean place to be laid down.
PAGE 4
STEP #19: Same as Step #10. STEP #20: Before installing valve body, note the levers in the transmission which engage the Manual Control Valve and the Downshift Valve. They must line up with the valve body properly. Downshift valve not used in competition units. STEP #21: Lift valve body into transmission, carefully aligning the Manual Control Valve (Fig. #1) with the Shift Linkage.
PAGE 5
CAUTION, VERY IMPORTANT: When installing the CHEETAH SCS Shifter, you must use the Turbo Action Shift Lever and Mounting Bracket supplied or otherwise improper alignment of shifter will occur causing possible transmission failure or miss shifts. CAUTION In a race car it is imperative that the forward gears be precise in relation to the shifter. STEP #30: Note Fig. #2 & #3 for position of Hairspring Cotter. For C4 it is outside, away from transmission. For C6 it is inside, towards transmission.
PAGE 6
FIGURE #1 (See STEPS #12 and #21) Manual Control Valve Downshift Valve C4 and C6 Valve Bodies Similar (C6 Shown) Part #70003B 6 10/93,9/98,2/01,5/06
PAGE 7
FIGURE #2 C4 Cable/Bracket Installation Hairspring Cotter on outside. FIGURE #3 C6 Cable/Bracket Installation Hairspring Cotter on inside.
PAGE 8
Fig. #4 Installation of Switch & Switch Nut into Switch Mounting Bracket Fig. #5 Installation of Switch, Switch Nut & Mounting Bracket Assembly Underneath Shifter Mounting Brackets Fig.
PAGE 9
#70166 SCREW #70061 #70064 T-HANDLE SPRING VIEW A PUNCH OUT CENTER SECTION WITH SMALL BLADE SCREWDRIVER NEAR OUTSIDE EDGE. #70200A SWITCH ASSEMBLY #70065 LIFTER Roll Pin SWITCH RETAINER (SEE VIEW A) 1535 Owens Road, Jacksonville, FL 32218 (904)741-4850 FAX (904)741-4853 Part #70003B #70063 #70066 10/93,9/98,2/01,5/06 DECAL 9 Fig.