Manualshelf

Owners Manual

ManualsBrandsTurbo Air ManualsCommercial Equipment12" Light Duty Manual Slicer with Top Mount Knife Sharpener, Hollow Ground Knife, Anodized Aluminum Construction and Permanently Lubricated Ball Bearing Motor
12345678910
10
DISASSEMBLE AND CLEANING
Wash and rinse both side of knife by wiping outward from the center carefully.
Never clean any part of the slicer with steel pads.
Do not exceed chemical manufacturer’s recommended concentrations for detergent of sanitizer.
Solution with concentrations greater than 200 ppm will accelerate corrosion of metals.
4. Knife cleaning
Carefully reassemble the knife cover over the blade. Hold the knife cover with one hand while tighten-
ing the knife cover release knob with the other hand. Reassemble the knife deflector by screwing the 2
small knobs.
5. Reassemble the knife cover and deflector
Wipe the gauge plate from the knife toward you. Never wipe the gauge plate toward the knife.
6. Gauge plate cleaning
• Do not exceed chemical manufacturer’s recommended concentrations for detergent or sanitizer.
Solution with concentrations greater than 200 ppm will accelerate corrosion of metals.
• Do not use any slicer base or motor in the water.
• Do not immerse slicer base motor in the water.
• Do not hose down slicer or splash excessively with water.
7. Clean and wipe down the entire slicer. Do not use steel pads.