Turbo Air Speeds up the Pace of Innovation J Series Refrigerators & Freezers Installation and Operation Manual Please read this manual completely before attempting to install or operate this equipment.
TABLE OF CONTENTS SPECIFICATIONS / SERIAL NUMBER 2-3 FOR HYDROCARBON REFRIGERATION UNITS 5-6 NOTICE 4 IMPORTANT SAFETY INFORMATION 7-10 NOTICE TO CUSTOMER 11 INSTALLATION 11 PART NAME AND FUNCTION 12 DISPLAY PANEL OF REFRIGERATOR/FREEZER 13 DISPLAY PANEL OF DUAL TEMP.
SPECIFICATIONS Undercounter Refrigerators MODEL COM H.P. V/Hz REFRIGERANT AMPS WEIGHT JUR-36-N6 1/6 115V/60Hz R-600a 1.7 157 lbs. JUR-48-N6 1/5 115V/60Hz R-600a 2 184 lbs. JUR-60-N6 1/5 115V/60Hz R-600a 2 205 lbs. JUR-72-N6 1/5 115V/60Hz R-600a 2 239 lbs. Undercounter Refrigerators - Narrow MODEL COM H.P. V/Hz REFRIGERANT AMPS WEIGHT JUR-36S-N6 1/6 115V/60Hz R-600a 1.7 145 lbs. JUR-48S-N6 1/6 115V/60Hz R-600a 1.7 160 lbs.
NOTICE • This equipment is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instructions concerning the use of this equipment and the hazards involved by a person responsible for their safety.
FOR HYDROCARBON REFRIGERATION UNITS WARNING This unit uses R-290 (propane), or R-600a (isobutane) as a refrigerant. These hydrocarbon refrigerants are highly environmentally compatible but also are flammable and combustible. Please read this manual thoroughly before installing and operating the unit. Please take cautious measures to avoid risk of fire or explosion. PLEASE REFER TO THE LABEL INSIDE THE CABINET TO CHECK REFRIGERATION TYPE AND VOLUME. DANGER - Risk of fire or explosion.
FOR HYDROCARBON REFRIGERATION UNITS WARNING • Handle the unit with care in order to avoid any serious damage to the refrigeration system. • The refrigerant tubing, condenser, and evaporator coils are prone to damage while handling, moving, installing, and cleaning the unit, which may lead to fire or even explosion. • Refrigerant squirting out of the pipes could ignite or cause an eye injury.
IMPORTANT SAFETY INFORMATION SAFETY PRECAUTIONS To avoid any risk of fire, explosion, electric shock, personal injury, material damage or incorrect use of the appliance, be sure to observe the following safety precautions (After reading these owner’s manual instructions, please keep the manual booklet in a safe place for reference. Remember to hand it over to any subsequent owners). WARNING • The unit must be installed and located in accordance with the manufacturer’s installation instructions.
IMPORTANT SAFETY INFORMATION INSTALLATION & USAGE WARNING • Do not install the unit in a damp place where it could be splashed with water. Incorrect insulation of the electrical parts may cause fire or electric shock. • Do not plug several appliances into the same sockets. This could cause fire due to overheating. • Keep the power plug away from the rear of the cabinet. A damaged power plug may cause fire due to overheating. • Do not spray water directly to the interior or exterior of the appliance.
IMPORTANT SAFETY INFORMATION INSTALLATION & USAGE CAUTION • There is a risk of death from suffocation if a child puts the packing materials on his or her head. • Do not store any articles on top of the appliance. Articles may fall while opening or closing the door, and could cause personal injury or material damage. • Do not store pharmaceutical products, scientific materials or other temperature-sensitive products in the refrigerator.
IMPORTANT SAFETY INFORMATION PROPER DISPOSAL OF OLD APPLIANCE For environmental purposes, refrigeration appliances must be properly disposed. This applies to your old appliance, and at the end of its service life, for your new appliance as well. WARNING Before disposing of old appliances, make them inoperable. Remove plug from mains, severe the power cable, and remove or destroy any snap or latch closures.
NOTICE TO CUSTOMER Loss or spoilage of products in your refrigerator/freezer is not covered by warranty. In addition to following recommended installation procedures, you must run the refrigerator/freezer 24 hours prior to usage. INSTALLATION 1. LOCATION - Allow adequate space and install the refrigerator on a firm and level floor. If the appliance is not level, there may be unusual noises and poor cooling performance. 2.
PART NAME AND FUNCTION 1. THE STRUCTURE OF SANDWICH / SALAD UNITS PAN SHELVES EVAPORATOR STRONG COOLING CYCLE DOOR COOLING AIR EXIT COOLING AIR ENTRANCE SIDE COVER DISPLAY PCB FRONT COVER MAIN PCB CONDENSER FAN MOTOR 2.
DISPLAY PANEL OF REFRIGERATOR AND FREEZER BASIC OPERATION 1. Plug in and turn on the power switch located on the top side of the unit front cover. The display panel will be lighted and make a beep sound. The compressor will begin to run. 2. The default temperature setting is No. “4”. 3. The compressor is automatically cycled by the electronic controller (PCB). 4. The defrost cycle is automatically controlled by the PCB. 5. Set level toward “1” for higher temperature and “8” for lower temperatures. 6.
DISPLAY PANEL OF DUAL TEMP BASIC OPERATION 1. Plug in and the display panel will be lighted and make a beep sound. The compressor will begin to run. 2. The compressor is automatically cycled by the electronic controller (PCB). 3. The defrost cycle is automatically controlled by the PCB. 4. Good air flow in freezer/refrigerator unit is critical. Be careful to load product so that it neither presses against the back wall, nor reaches within four inched from the evaporator compartment.
CAUTION MARK AND NOTE PROHIBITION WARNING It is dangerous for people NO SCREW NO TOUCH CAUTION OBEY It will cause injury to human or lost of property Be sure not to put more plug in the socket. PLUG OFF Please use a dedicated socket! - Overheated wire will cause fire! Be sure not to spray flammable aerosol around the product! - Explosion, fire etc. Wet hands off the power - Life is in danger. Be sure not to allow children to enter the product! - Life is in danger.
CAUTION Do not put bottled drinks in the refrigerator for a long time. Please do not disassemble, repair or alter products! - Frost crack - Fire, electric shock etc. Be sure not to touch the power when the gas leak. Disassemble all the switch gear before scrap. - Leave the scene quickly after opening the windows. - It hides danger when the children play in the unit. Please do not damage the power cord. Please do not squeeze the power so that it is damaged. - Fire, electric shock etc.
CAUTION Please choose the environment without rat to set the product. When the abnormal situation occurs, unplug the power then contact the nearest service center. - Damage the power that will cause fire. Do plug the power without dragging! Please ask more people to carry the unit. - Wire breakage - No tilt. No object on top of unit. Be sure not to disassemble or replace the power which is damaged. - Electric shock, fire, explosion etc.
CAUTION Be sure not to put pharmaceuticals and chemicals. Be sure to avoid the children touching the unit. - It will result in an explosion. - It is dangerous. Please keep the plug clean. Be sure not to put hot food in the unit. - The dust and water will cause short circuit. Please use the leakage protector to prevent the short circuit. Be sure not to plug in the loose socket. - Fire, electric shock etc. Not touch the top and bottom of unit. Be sure not to store volatiles and combustibles.
INSTALLATION AND OPERATION INSTALLATION NOTE Be sure to set the unit in door. Be sure that the location be chosen has a strong enough floor to support total weight of the cabinet and other contents. - To prevent damage, leakage. - The uneven will make noise and shake. Be sure to avoid corrosive environment. Be sure no object is on the top of the product. - It will shorten the life of the unit. - The objects will fall to hit the unit. Be sure to avoid damp and dusty environment.
CLEANING AND PRECAUTION CLEANING - UNPLUG THE REFRIGERATOR CLEANING THE INTERIOR AND EXTERIOR - To maintain proper refrigerator performance, the condenser coil must be free of dust, dirt and grease. - This will require periodic cleaning. Condenser fins should be cleaned at least every three months (90days) or needed. - Please clean the product with a soft damp cloth. When the product is too dirty, please use the cloth with a little of neutral detergent. - Pull out the shelves to clean.
TROUBLESHOOTING SYMPTOMS CAUSES SOLUTIONS Cooler is freezing food. • Thermostat set too cold. • Turn the thermostat setting to a higher temperature position The unit does not refrigerate at all. • There is a power connection failure problem. • Check the power cord and plug in correctly. The unit does not refrigerate well. • The unit is in sunlight or near a heating device. • The unit contains hot food or too much food. • The unit door is opened too frequently or left open too long. • The temp.
STAINLESS STEEL EQUIPMENT CARE AND CLEANING CAUTION : Do not use any steel wool, abrasive or chlorine based products to clean stainless steel surfaces. There are three basic things which can break down your stainless steel’s passivity layer and allow corrosion to occur. 1) Scratches from wire brushes, scrapers, and steel pads are just a few examples of items that can be abrasive to stainless steel’s surface. 2) Deposits left on your stainless steel can leave spots.
STAINLESS STEEL EQUIPMENT CARE AND CLEANING 4. Water Treatment To reduce deposits, soften the hard water when possible. Installation of certain filters can remove corrosive and distasteful elements. Salts in a properly maintained water softener can be to your advantage. Contact a treatment specialist if you are not sure of the proper water treatment. 5. Maintaining the cleanliness of your food equipment Use cleaners at recommended strength (alkaline, alkaline chlorinated or non-chloride).
WARRANTY INFORMATION TWO (2) YEAR WARRANTY Warranty Claims... All claims for parts or labor must be made directly through Turbo Air. All claims should include: model number of the unit, the serial number of the cabinet, proof of purchase, date of installation, and all pertinent information supporting the alleged defect. In case of compressor replacement under warranty, either compressor or compressor tag must be returned to Turbo Air along with above listed information.
WARRANTY INFORMATION What is Not Covered by This Warranty... Turbo Air’s sole obligation under this warranty is limited to either repair or replacement of parts, subject to the additional limitations below. This warranty neither assumes nor authorizes any person to assume obligations other than those expressly covered by this warranty. NO CONSEQUENTIAL DAMAGES.
NOTE 26
Warranty information card must be submitted via post mail or electronically on our website at www.turboairinc.com/registration within 7 days from the date of purchase. Failure to comply may result in your warranty being voided. WARRANTY REGISTRATION CARD MAIL CARD IMMEDIATELY OR GO TO ONLINE REGISTRATION AT www.turboairinc.
4184 E. Conant St., Long Beach, CA 90808 Toll Free: 1-800-381-7770 Fax: 310-900-1033 Email: warranty@turboairinc.com www.turboairinc.
