Turbo Air Speeds up the Pace of Innovation Glass Door Freezers Installation and Operation Manual Please read this manual completely before attempting to install or operate this equipment FREEZERS TGF-23F(B) TGF-49FE(B) TGF-72F(B) www.turboairinc.
CONTENTS PAGE 1. SPECIFICATIONS ....................................................................................... 2 2. SERIAL NUMBER ........................................................................................ 2 3. INSTALLATION ............................................................................................ 3 4. CLEANING & CAUTION .............................................................................. 4 5. BASIC OPERATION ................................................
INSTALLATION 1. GOOD AIR CIRCULATION - Be sure to avoid any object which will restrict exhaust air flow - Be sure that there is ample air space so that air can flow through the rear of the unit - Turbo Air recommends that the rear of the unit be no less than 5 inches from the wall 2. PLACE ON STRONG GROUND - Be sure the location chosen has a floor strong enough to support the total weight of the cabinet and contents 3.
CLEANING 1. CLEANING THE INTERIOR AND EXTERIOR - The interior and exterior of the unit can be cleaned using warm water with soap - Do not use an abrasive cleaner because it will scratch the surface 2. CLEANING THE CONDENSER FINS - To maintain proper refrigeration performace, the Condenser coil must be free of dust, dirt, and grease This will require periodic cleaning. Condenser fins should be cleaned at least every three months (90 days) or as needed 3.
BASIC OPERATION 1. Plug in and turn on the power and lamp switch located on the top of the bottom grille right side. The Display panel will be lighted and make a beep sound. The compressor will begin to run. After turning on the power, the fluorescent lamp will come on in a few minutes. 2. The default temperature setting is No. “-8˚F” for the TGF-23F. The default temperature setting is No. “-8˚F” for the TGF-49FE. The default temperature setting is No. “-8˚F” for the TGF-72F. 3.
DISPLAY PANEL OF FREEZER (TGF-23F) TEMP CONTROL BUTTON (SEE PAGE 8) LAMP SWITCH INTERIOR TEMP INDICATOR (SEE PAGE 9) POWER SWITCH TEMPERATURE Turbo air LAMP T.F.
DISPLAY PANEL OF FREEZER (TGF-49FE, TGF-72F) TEMP CONTROL BUTTON (SEE PAGE 8) LAMP SWITCH INTERIOR TEMP INDICATOR (SEE PAGE 9) POWER SWITCH LAMP POWER TEMPERATURE T.F.
TURBO FREEZE 1. If you push the T.F. (Turbo Freeze) button, the compressor will run for 120 minutes to bring down the temperature more quickly. 2. If you push the T.F. button again during Turbo Freeze mode, the compressor will return to the normal operation. 3. During the Turbo Freeze mode, the temperature Up/Down button will not affect the compressorʼs operation. UP/DOWN BUTTON (Temperature control button) 1. By pushing the up/down button, you can set the inside temperature from ʻ5˚Fʼ to ʻ-17˚Fʼ. 2.
INNER TEMPERATURE DISPLAY 1. It displays inside temperature. 2. Display range is -50˚F to 50˚F (-45˚C ~ +10˚C). 3. When inside temperature is lower than -50˚F, the panel will display ʻ and, higher than +50˚F, the panel will show ʻ ʼ. ʼ. AN RUNNING INDICATOR 1. If the fan motor is running, fan running indicator will be turned on. 2. Evaporator fan motor is stopped when the door is opened. DOOR OPENING INDICATOR 1. If any door is opened, door opening indicator will be turned on. 2.
TROUBLESHOOTING SYMPTOMS CAUSES SOLUTIONS Freezer is melting food • The setting temperature is too high to contain food fresh. • Push the temperature down button for lower temperatures. The unit does not refrigerate at all • There is a power connection failure problem. • Check the power cord and plug in it correctly. The unit does not refrigerate well • The unit is in sunlight or near a • Check the installation place. heating device.
MANUFACTURING COMPANY TWO YEAR WARRANTY Turbo Air warrants to the original purchaser of every new Turbo Air refrigerated unit, the cabinet and all parts thereof, to befree from defects in material or workmanship, under normal use and service, for a period of two (2) year from the date of original installation or 27 months after shipment date from Turbo Air , whichever occurs first.
What is NOT covered by this warranty Turbo Airʼs sole obligation under this warranty is limited to either repair or replacement of parts, subject to the additional limitations below. This warranty neither assumes nor authorizes any person to assume obligations other than expressly covered by this warranty. 1. WARRANTY IS NOT TRANSFERABLE. This warranty is not assignable and applies only in favor of the original purchaser/user to whom delivered.
Warranty Claims... All claims for parts or labor must be made directly thorough Turbo Air. All claims should include: model number of the unit, the serial number of the cabinet, proof of purchase, date of installation, and all pertinent information supporting the alleged defect. In case of compressor replacement under warranty, either compressor or compressor tag must be returned to Turbo Air along with above listed information. Failure to comply with warranty policies will result in voiding claims.