TPR Series Manual

5
INSTALLATION
BASIC OPERATION
1. GOOD AIR CIRCULATION
- Do not place any object that will restrict air flow in front or back grills.
- Turbo air highly recommends that there is ample space in rear of unit. 5 inches or
more is best.
2. PLACE ON STRONG GROUND
- Be sure the location chosen has a floor strong enough to support the total weight of
the cabinet and contents.
3. DO NOT PLACE NEAR HEAT
- Be sure to avoid hot corners and locations near stoves.
- High ambient temperature will make cooling efficiency lower.
4. INDOOR USAGE ONLY
- Be sure to install this unit indoor, so it will not get wet from the rain.
5. STABILIZING
- Make sure the unit is installed in a stable condition with the front wheels locked
while in use.
6. LEVELING
- Be sure that the unit is level from front to back and side to side.
7. UNIT SHOULD BE ON DEDICATED OUTLET.
1. The controller(thermostat) is located at the right inside of the unit.
If thermostat knob is pointing at OFF,
compressor and condenser fan motor would not run.
Keep unit unplugged, if not in use for a long period of time
2. The factory setting for the control is ʻNormalʼ, and maintains about 38˚F (3˚C) inside.
3. Set toward
4. The thermostat controls compressor’s cycling by sensing inside temperature.
5. When unit will not be used for a long time, turn the power switch off located under the
thermostst knob.
“Cool” for higher temperature and “Cold” for lower temperature.
REFRIGERATORS
OFF
COOL
COLD
NORMAL
Temperature Controller
(Thermostat)