Use and Care

9
BASIC OPERATION
TSF-23SD
TSF-35SD
TSF-49SD
TSF-72SD
1. Plug in and turn on the power switch located on the bottom of the top grille
right side. The Display panel will be lighted and make a beep sound. The
compressor will begin to run.
2. The default temprature setting is No.”5”.
3. The compressor is automatically cycled by the electronic controller (PCB, F-Senser).
4. The Defrost cycle is automatically controlled by the D-sensor, and the PCB.
5. Set level toward “1” for higher temperature and toward “9” for lower temperatures.
6. The interior light is activated by the rocker switch at the bottom of the grille when
the door is opened.
7. Evaporator fan motor(s) will run after all doors are completely closed.
8. Good Air Flow in Freezer unit is critical.
(Be careful to load product so that it neither presses against the back wall,
reaches within for inches from the evaporator compartment.)
FREEZERS